Quartz rod
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1 Piece pc
- Supply Capability:
- 1000000 Pieces per Year pc/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Specifications
Quartz rod used in quartz welding,semiconductor industry,high quality welding
Character of Quartz rod:
Product | Code | OH PPM | category | Application |
Transparent Quartz rod
| FDB600 | <150 | Unbaked,GE214LD PH300/308, Ovisil451 | Quartz welding,used in semiconductor industry |
FDB600 | <150 | Unbaked,GE214LD PH300/308, Ovisil451 | High-quality welding |
Range of OD |
OD |
WT |
Siding |
Ovality |
Bow/1220mm |
<5mm |
<62.0% |
<68% |
10% |
1.5% |
<2.5mm |
5mm-13mm |
<61.5% |
<68% |
8% |
1.2% |
<2.5mm |
13mm-30mm |
<61.5% |
<67% |
8% |
1.0% |
<3.0mm |
30mm-80mm |
<61.5% |
<68% |
8% |
1.0% |
<3.0mm |
Chemical element |
Al |
Fe |
Ca |
Mg |
Li |
K |
Na |
Ti |
Complexity
analysis |
23.2 |
4.8 |
3.1 |
2.5 |
2.0 |
5.4 |
6.1 |
|
Capability |
Reference |
Capability |
Reference |
Softening point |
1620C |
Coefficient of thermal expansion (20-230C) |
5.6x10-7cm/cm.C |
Back spot |
1170C |
Heat conductivity(20C) |
1.4W/m.C |
Strain point |
1100C |
Specific heat(20C) |
670J/kg.C |
Density |
2.2g/cm3 |
Electric calresistivity(350C) |
7x107ohm.cm |
Hardness |
5.5-6.5Mohs |
Dielectric constant |
3.75 |
Tensile strength |
4.8x107N/m2 |
insulation strength |
5x107V/m |
Compression strength |
1.1x109N/m2 |
|
|
- Q: Why can quartz glass heating tubes be heated?
- Heating or electric heating, just inside the quartz tube.
- Q: The difference between infrared heating tube and quartz heating tube
- Use stainless steel heating tubes! The temperature is even. The quartz heating tube is heating up too fast. It's easy to bake the mobile phone cover.
- Q: Is the heating tube in the oven better quartz or stainless steel?
- It is better for families in the economy, but for families who want to buy electric ovens and singles. The other is an electric oven with two far-infrared tubes and a quartz heating tube, which is characterized by faster heating. However, compared with the former, the price should be slightly higher, generally expensive one hundred or two hundred yuan.
- Q: Comparison of micro crystalline quartz tube grill with copper tube grill
- Copper, iron pipe barbecue (obsolete), poor corrosion resistance, in case of water vapor, soot aging, poor insulation, short service life. The temperature is only 56.8 degrees centigrade. After the power failure, the temperature is reduced by 5 degrees per minute, the insulation effect is poor, the use is not safe, and the speed of cooling is slow, time consuming and electricity consuming.
- Q: What is the difference between the performance of the quartz ozone tube and the ceramic ozone tube?
- Quartz discharge tubes are usedThe quartz discharge tube is open type, the ozone equipment is equipped with a large air volume blower, and the ozone diffusion is fast, and the quick sterilization effect is achieved. The quartz discharge tube is more suitable for large space use, and the ozone generator has large gas consumption and relatively good bactericidal effect
- Q: Electronic energy saving heater and quartz tube heating rod
- The electric heater converts the electric energy into heat energy through the electric heating element, and the good electric heating element can not convert the electric energy 100% into the heat energy.
- Q: What are the defects of the ceramic heater and quartz tube heating?
- The ceramic PTC has high heating efficiency and no open flame, and the hot air circulation flows out heat energy to the space.
- Q: The difference between quartz tube and far infrared tube in an electric oven
- In the electric oven, the quartz tube is an electric heating tube made of quartz as the tube wall, and the red electric heating wire can be seen when heating.
- Q: Which is better, quartz glass heating tube and PTC heating tube?
- Good afternoon, this is to see what you are for. Quartz glass heating tube is cheap and slow heating, and because of the expansion coefficient of quartz can not be used in a larger temperature change environment, so as not to burst.
- Q: What's the difference between a quartz tube, an enamel tube and a glass tube?
- Glass tubes are made of ordinary glass and have less heat resistance.
1. Manufacturer Overview
| Location | Liaoning,China |
| Year Established | 1986 |
| Annual Output Value | US$2.5 Million - US$5 Million |
| Main Markets | North America South America Eastern Europe Southeast Asia Africa Oceania Mid East Eastern Asia Western Europe Central America Northern Europe Southern Europe South Asia |
| Company Certifications | ISO 9001:2000;TUV; CE; ROHS;MSDS |
2. Manufacturer Certificates
| a) Certification Name | |
| Range | |
| Reference | |
| Validity Period |
3. Manufacturer Capability
| a) Trade Capacity | |
| Nearest Port | Dalian port |
| Export Percentage | 91% - 100% |
| No.of Employees in Trade Department | 6-10 People |
| Language Spoken: | English, Chinese, Japanese, Korean |
| b) Factory Information | |
| Factory Size: | 3,000-5,000 square meters |
| No. of Production Lines | 4 |
| Contract Manufacturing | |
| Product Price Range | Low and/or Average |
Send your message to us
Quartz rod
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1 Piece pc
- Supply Capability:
- 1000000 Pieces per Year pc/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
