Cree Led Lamp Dimmable

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT or LC
Min Order Qty:
100 Pieces pc
Supply Capability:
5,0000 Pieces per Week pc/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:


Specification of Cree Led Lamp Dimmable 

Input voltage(V): 100~240


Out put current:700MA

Constant current precision:5%

Power factor: 0.95

Dielectric strength(V/AC): 3000

Light efficiency(LM/W-CW): 60



We are professional and pubic Led lighting products manufacturer Our advantages are : professional, high quality, reasonable price, timely delivery ,excellent services and strong supply ability.


Our main products are LED light and driver.the most advantage of our products is that they are Dimmable,

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:How to use digital multimeter to detect the quality of 36 volt low voltage lighting transformer?
The number of tables in this table is increasing when the table rings to show 1.Method 2 is only to measure the capacitance is good or bad, can not be measured capacity.
Q:Which is more energy saving by using 24V500W transformer lighting and 220V500W lighting?
See whether the lamp power saving, can not see whether it has a transformer, but to see the light efficiency of the lamp, that is, the ratio of light flux to power!Popular speaking, that is, spend the same electricity to see who sends more light!So, when comparing, ask what the light is, then judge again!The luminous efficiency unit is LM/W
Q:Lighting, lights, transformers, bulb brightness is too low, what's the matter?
Line light for safety light, voltage 24 volts and 36 volts, pay attention to the bulb and transformer voltage matching.
Q:The difference between lighting transformers and control transformers
The lighting voltage is 36 and 12V, the signal lamp is 6V, the control winding is 127, 110V, the one or two insulation, and the two one is grounded.Simple lighting transformers, the two voltage is not so diverse.
Q:Why is elevator lighting transformer installed?
1) a lamp shall be installed at the highest and lowest point 0.5m away from the hoistway, and a light shall be installed at intervals not exceeding 7m, and a control switch shall be installed in the engine room and the bottom pit respectively;2) the lighting power supply for car top and hoistway shall be 36V; when 220V is adopted, the residual current action protector shall be installed;3) there is no lighting device for a closed well road with sufficient lighting conditions around the hoistway.
Q:Line lights, lighting transformers in use!! Can live line work?!! Be afraid of electric shock 40
Line lights, lighting transformers in general how many low voltage, can live operation, but to do safety measures. For example, do not short-circuit, damp environment, wear insulation shoes, wearing insulating gloves and so on.In fact, all the voltage levels, as long as safety measures can be done live operation.
Q:Why can't autotransformer be used as transformer for safety lighting?
The main and auxiliary coils of the autotransformer have common parts. Once the short-circuit is made, the lighting circuit is directly connected with the high voltage circuit, which is very dangerous
Q:Why is the two side of the lighting transformer grounded?
Single-phase transformer two side lighting to the ground, on the one hand is the lighting products now contain many semiconductor devices such as diodes, transistors, integrated circuits, semiconductor devices vulnerable to electrostatic damage, two side grounding contributes to the surge pressure factors produced by residual electrostatic discharge stay in the main circuit, avoid electrostatic protection, product life. In the 21 aspect, there is distributed capacitance between the two side and the primary side of the power transformer, and the high frequency surge disturbance caused by the primary side current source will directly enter the two side to the main circuit through the distributed capacitor. These unnecessary high frequency interference may jump into the sensitive signal source, make the control system malfunction, and the two side grounding of the power transformer can eliminate most of the undesirable effects of the distributed capacitance.
Q:How to calculate the rated capacity of small transformers for lighting purposes?
If the flow of large capacity motor starting current and welding machine, large current flows in a short period of time in the load even when the power equipment capacity can withstand current flow in a short time, but due to a voltage drop excitation electromagnetic switch relief, the motor can not start, damaged or the undesirable phenomenon of welding. Therefore, the voltage drop rate should be calculated as less than 10% of the supply voltage, as calculated below.
Q:What type of low voltage transformer should be adopted for safety lighting power supply?
Isolated transformer, once 380V or 220V, two voltage, 36V, 24V, 12V, several categories, do not allow the use of autotransformer.
We hold the service idea of "high beginning and high standard", in order to get rid of the condition of low level competition. We promise that our products are always advanced, steady, and long-lasting. We will keep up the product value and realized clients' dream by consistent innovation. We will absorb the latest research outputs, and keep an open mind to study from top enterprises. On the basis of independence, we strongly believe that we can become a new bright star through perseverance.

1. Manufacturer Overview

Location Guangdong,China (Mainland)
Year Established 2011
Annual Output Value
Main Markets North America 10.00%
South America 2.00%
Eastern Europe 20.00%
Oceania 20.00%
Mid East 2.00%
Eastern Asia 1.00%
Western Europe 40.00%
Southern Europe 5.00%
Company Certifications ETL; C-tick; CE

2. Manufacturer Certificates

a) Certification Name  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port Shenzhen,HK
Export Percentage 91% - 100%
No.of Employees in Trade Department 6-10 People
Language Spoken: English, Chinese
b)Factory Information  
Factory Size: Below 1,000 square meters
No. of Production Lines
Contract Manufacturing
Product Price Range