Explosion Proof Led High Bay Lighting

Hot Products

FAQ

Led how much is a lamp for industrial and mining lamps, and the workshop is 7 meters high?
1. according to the national standard, the general lighting lamps in workshop and warehouse, is 200LUX, if you shop 7 meters high, we recommend you to use 55W-100W installed a spacing: 20-23m2, mining lamps installed at the factory only as basic lighting, do not need to use the lamp illumination illumination to reach 400-500, the basic can be. High intensity work requirements should be determined by the working position of lighting to complete, such as workshop on employees in some water on the head of 20CM installed around the rows of the lighting lamp, it can save the cost and the effect will be better, except in special places of course.
At present, LED mining lamp is used in many high power lamp?
The mining lamp is more single 1W beads, stable performance; there are some integrated modules ranging from 50-100W.
LED what are the parameters of industrial and mining lights?
Operating temperature, lighting efficiency, power factor, temperature rise, protection grade, lampshade type, service life, illuminance and so on
What are the advantages and disadvantages of LED industrial lamps compared with traditional lamps?
Compared with the traditional high ceiling LED mining lamp, more energy, more safe, more environmentally friendly, but on an environment in the end is to use LED mining lamp or the use of traditional high lamp, look at the actual situation of the plant to order, if the plant height more than 7 meters above the high ceiling, recommend the use of traditional gas discharge light source, if 7 meters below, and customers are willing to use LED lamps, consider using LED mining lamp!
How many W LED industrial and mining lights are generally used in a 18 meter workshop?
I want to see what your workshop is for. I'll try to make an example. The lighting of the precision parts must be much higher than the cardboard. This is to be calculated to know.
A LED mining lamp with what is the impact on the lighting?
Of course, this should be to match according to the height of the illumination, generally divided into broad and deep cover plate, height is used in deep hole
Why does the LDo you trip when charging?Check that the LED wick or battery has a short circuit.ED miner light trip?
1 、 Industrial and mining lamp leakage2, short circuit3 、 the power is too large, the air switch is too small
I would like to ask, 1000 square meters of factory buildings should be equipped with LED industrial and mining lights, plant width 12M, high 8m, the factory is new, how to decorate, how much work required?
Don't listen to the upstairs SB, now LED technology is very mature, electrodeless lamp is obsolete products. I suggest you use industrial and mining lights