Q:Can the inlet and outlet of butterfly valve be reversed? Why? What will happen if the reverse gear is installed?

Our factory butterfly valve has two-way sealing, can be installed, and will not leak. If there is an arrow above the butterfly valve is one-way seal, that is, can not be installed. One way sealing will cause leakage. If you have any other questions, you can bring them up. Let me help you with that

Q:Three eccentric hard sealing butterfly valve, why not fit in the end of the pipe?

The sealing ring will hold up. It does not fit in with the flange end of the pipeline, this addition is the most common and convenient pipeline after purge and easily add pipeline.

Q:How can the flange butterfly valve be installed on the pipe?

Direction.Butterfly valve in theory can be installed in any direction, it is recommended that the horizontal installation of the valve shaft installation, so that both ends of the bearings will not be at the bottom (below), so as to avoid sediment in the media into the bearing.Inlet pipe configuration.There are water inlet side valve elbow, tee pipe fluid caused by bending and uneven distribution of the inflow valve, the drift will occur in the pipe, so it must be generated by the uniform drift disposed on both sides of the disc, so as to avoid uneven force on both sides of the disc, and may produce additional torque.

Q:Types of butterfly valves

Butterfly valve structure categories: central to clip butterfly valve, central flange butterfly valve, single eccentric butterfly valve, double eccentric butterfly valve, eccentric butterfly valve, soft sealing butterfly valve, hard sealing butterfly valveButterfly drive categories: handle, worm gear, electric, pneumatic, electromagnetic, electromagnetic, hydraulic, electro hydraulic, hydraulic, hydraulic, pneumatic

Q:In the pipeline attached building Atlas 05S502, in the middle of a water meter and check valve, the two sides are divided into two butterfly valve, want to ask why to arrange this way, what is the role of the two butterfly valve?

Check the water gauge and check valve on both sides to facilitate the maintenance and replacement of water meter and check valve.

Q:can't locate freon intake valve for 03 jaguar an was wondering were it is located at

Most manufacturers put the fill nozzle on the hoses, either the high or/and the low side. Also, the low side can be found on the accumulator.

Q:What is the meaning of the D341*5-10 / 16ZB1 turbine butterfly valve flange said?

D: for clamp, 3: turbine head 4: flange connection 1: vertical plate X5: Ding fine rubber 10/16: nominal pressure Z: gray cast iron valve body, B1: valve plate material is ductile iron

Q:What's the meaning of butterfly valve d371po?

According to the provisions of the JB/T 308-2004 valve type programming method:D== butterfly valve3== transmission: worm gear7== connection mode: clip type1== structure: midlinePo== sealing surface material: lining PoPo== propylene oxide (PO)

Q:My caravan is a bit sluggish on the pick up, I replaced the wires/plugs and the electronic distributor(I think thats what it is..). still a bit sluggish. Should i look at the valve gasket? Or fuel filter, or fuel pump next? 03 caravan sport 3.3L

There is no electronic distributor on your caravan it uses a coil pack To the 1st poster there is no valve pan gasket you have valve cover gaskets. The fuel filter on your van is Incorporated in the fuel pump module located inside your fuel tank. There a several things that can contribute to sluggish performance, look at your exhaust and make sure it is not bent/collapsed/restricting Dodge Chrysler Jeep Tech

Q:Fire, the signal butterfly valve flange connection or welding?

Grooved flange joint, welded flange connection! Wire bonding. Wire to flange connection! In addition, you can choose the groove type signal butterfly valve!