Q:Introduction of gantry planer

Gantry planer table with the workpiece through the door frame for a straight reciprocating motion, empty stroke speed is greater than the working stroke speed.

Q:Ngau Tau planer infeed is not uniform

Followed by the knife when the lock on the lock slightly tightened to reduce the gap between the Nandao knife, the turret on the clapper is loose.

Q:Torch of the Shaper Planer Reciprocating Stroke Starting Position Stroke Length How does the feedrate be adjusted?

First release the Nou Tau lock block, and then counterclockwise release the spindle slider lock nut,

Q:The typical structure of the planer

2-Sliding Gear Set 3, 4 Gear 5-Eccentric Slider 6-Pendulum 7-Down Fulcrum 8-Slip 9-Screw 10-Screw Nut 11-Handle 12-Shaft 13,14-Bevel Gear

Q:The operating rules of the planer

2, the air run before the test, you should first hand wheel to make the ram back and forth movement, to confirm the situation is good, and then mobile operation.

Q:A senior graduation design topic is: the use of adams to do the design of the guide plate

If you think adams modeling more complex can be used after modeling 3D software into adasm

Q:What is the "planer"?

The planer is moved from the table with the workpiece through the gantry frame, and the difference between the single-planer and the planer is only one column, so it is suitable for workpieces with large width without machining on the whole width.

Q:Planer's planer how to grind is the best?

Explained under the grinder for the double-sided grindstone (one side of a rough side of the hand) holding the planer down the pressure, with a grindstone rough surface of the planer grinding into a section of 40 degrees, parallel to pull back and forth (planer and grinding

Q:Self-learning CNC planer operation programming? I want to learn CNC planer operation and programming should learn from?

First learn the coordinates of CNC machine tools, you can see Baidu Encyclopedia - machine coordinate system.

Q:Planer, slot machine, gantry milling machine in the application of what is the difference

In addition to being able to make vertical and horizontal intermittent feeds, the workbench can also be intermittently swivel in the circumference of the room.As with the planer, the productivity and precision of the cutting bed are low, mostly for single or small