Q:Planer planer

Lift the knife board to be flexible, or planer back with the processing surface scratching, easy to lead to blade damage; also should not be too large, the gap is too large, planer will swing around, the return process will scratch with the processing surface, damage the blade.

Q:This is the meaning of each stage of the gantry plan

Simply can say that you can be divided into two stages, one is the departure phase is T1 --- t5

Q:What is the mechanism of the table feeding mechanism?

The tool or workpiece is a reciprocating straight motion that consists of the workpiece and the tool for the intermittent feed movement perpendicular to the main movement.

Q:What is the difference between the planer and the planer?

Door planer: mainly used for planing large parts, but also in the table with a number of parts at the same time processing.

Q:The main movement and feed movement of the following processing methods (indicating whether the workpiece or tool is rotating or moving): The end of the vehicle, the interior of the car, the planer

Nautus planing plane: reciprocating linear motion of the main moving tool post, feed movement table moving indirect transverse

Q:Seeking woodworking planer planer installation method! I do woodworking for many years, do not know if my installation method is wrong or what, each time you install the blade can let

then in order to lock the nut in general can easily get.

Q:Newcomer asked, fitter was found how to do, run it

You can use the omnipotent angle to draw, or use the trigonometric function to calculate the dovetail slot X, Y coordinates, and then use the steel ruler, scribe line to connect the coordinates can be.

Q:What is the significance of rapid return characteristics in production?

The use of this feature in the machine can significantly shorten the empty stroke of the component, shorten the machine's invalid working hours, improve work efficiency.

Q:What are the operating procedures that workers should follow on the planer?

(1) work should wear overalls, lesbians should wear a work cap, hair stuffed in the work cap.

Q:What is the problem with the daily maintenance of the bulldozer?

If you want the machine to be able to be fully lubricated, then the oil on time and refueling and inspection to promote the maintenance of adequate and clean lubricants.