Q:Are there any requirements for the weld grade of the curtain wall connection? Thank you!

General curtain wall of the weld if there is no special requirements, then the three welds.

Q:The installation method of the splicing jaws

Steel beams and glass are ready to ensure that the location is not wrong, as well as glass holes, adapter and steel beam welding no problem. Put the claws on the transfer, engage in tight. Put the splice on the glass, engage in tight, do not forget the middle of the gasket. Then, the glass is mounted, the splice is connected with the splicing jaws, but do not twist too tightly, and then adjust the position and adjust the error. Finally, tighten, check the next to ensure safety. Ordinary is so loaded, of course, there are different styles, installation methods are different, but not difficult.

Q:Curtain wall claw claw how much appropriate? How much is a square? Please professional answer, plus points plus points

250 series of four claws of the 480, two claws of the 300, single claw of 190. This is the price is more expensive, Kennedy commonly used splicing a 60 dollars, a base is 60.

Q:Stainless steel splicing claws attached to what steel structure above

Stainless steel splicing jaw pieces of the choice of models to see you mainly use the glass size, carrying the wind pressure, weight.

Q:Who knows which factory is good? Recommended!

Not bad money to buy hard, the best brand.

Q:How many errors can be made by welding the splicing jaws

General glass canopy or glass curtain wall in the construction process is the first welding of the most basic steel frame, steel frame after welding to the stainless steel splicing claw of the process, the first split the claw of the base welded to the steel frame , The base is also our terminology that the adapter, is used to fix the stainless steel splicing claws.

Q:What is the difference between tempered glass shed and tempered glass and canopy sunshine shed?

Is the same, because we must consider the safety factors, with less ordinary glass, commonly used is tempered glass and laminated glass. There are also a PC sunshine board, PC Nai Liban, whether it is light transmission, insulation, safety, service life, appearance, cold bending performance, better than the glass, but the cost of It is slightly higher!

Q:Tempered glass shed with 22o of the split jaws, how to calculate the location of the glass hole ah

Usually between the glass to stay 10mm glue, two pieces of glass split hole center spacing 220mm, hole to the glass edge of the distance: (220-10) / 2 = 105 mm

Q:Split jaw type 3O0 type open large holes, the glass on the opening of the hole

The larger the number of the larger the greater the material or the better the same material model of the price of expensive 150-type hole diameter 35

Q:Can the splicing jaw be welded to the stainless steel tube?

Split claws support structure and diverse, to meet the needs of different building structures and decorative effects. Part of the split jaw pieces with spherical hinge connection, with the ability to absorb deformation, in the security also has a great protection.