10KVA UPS Price with High Quality
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1 Piece pc
- Supply Capability:
- 2000 Pieces per Week pc/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Outstanding feature
1. Texas Instruments processor
2. Motorola Microprocessor
3. Module design
4. Advanced Current Control
5. IGBT power component
6. Power Factor Correction
7. Online Maintenance
8. High frequency and double conversion on-line technology
9. Advanced PFC technology
10. EPO Function
11. Wide input voltage range
12. Fully digitized microprocessor control
13. Parallel redundancy
14. Advanced battery management
15. Lightning and surge protection, short circuit and overload protection
16. Multilingual LCD display
Technical specification
MODEL | 6K(S)L | 10K(S)L | 3CRT10KSL | 3CRT15KSL | 3CRT20KSL |
Power(VA/Watt) | 6000VA/4200W | 10000VA/7000W | 10000VA/7000W | 15000VA/10500W | 20000VA/14000W |
INPUT | |||||
220 VAC, 1 Phase + Neutral | 220 VAC, 1 Phase + Neutral | 380 VAC, 3 Phase + Neutral | 380 VAC, 3 Phase + Neutral | 380 VAC, 3 Phase + Neutral | |
Voltage Tolerance | 176 – 276 VAC ± 3% | 176 – 276 VAC ± 3% | 304 – 478 VAC ± 3% | 304 – 478 VAC ± 3% | 304 – 478 VAC ± 3% |
Power Factor | ≥ 0.98 | ≥ 0.98 | ≥ 0.95 | ≥ 0.95 | ≥ 0.95 |
Current (nominal) | 23 Ampere | 37 Ampere | 13 Ampere / Phase - 39 A | 23 Ampere / Phase - 69 A | 30.3 Ampere / Phase - 91 A |
Input Fuse | 32 A NFB | 50 A NFB | 63 A NFB | 100 A NFB | 100 A NFB |
Frequency & FrequencyRange | 50 Hz, 46 ~ 54 Hz | ||||
Perfect Voltage and frequency Compatibility | |||||
0.65 inductive - 1.0 resistive | |||||
Sinusoidal | |||||
220 / 230 / 240 VAC ± 1% | |||||
At 50% - 100 - 50% unbalanced load, max voltage decline < ± 5% | |||||
At Dynamic load Changes, Output Voltage recovery time is 60 msec ± 1% | |||||
For Linear Load ≤ 2%, Non Linear Load ≤ 6% | |||||
50 Hz / Mains 46-54 Hz, Battery Mode ± 0.1% (0.05 Hz) | |||||
3:1 | |||||
For 105% - 130% load 10 mins., for > 130% load transfer to bypass after 1 sec, shutdown after 1 min at overloaded bypass | |||||
At > 105% load shut down after 10 sec. | |||||
Standard static bypass, Completely Uninterrupted transfer between Mains - Battery / Battery - Mains | |||||
176 – 261 VAC, 1 Phase + Neutral | |||||
Maintenance Free, Dry Type | |||||
240 VDC | |||||
LCD Panel | |||||
Push Buttons (Open / Close, Audible Alarm Cancellation) | |||||
% Load, Input Voltage Exist, Output Voltage Exist, Bypass Active, Battery Mode, Battery Capacity (%), Inverter in Service, Fault | |||||
Mains On, Mains Reverse, Battery Mode, Bypass On, Load / Battery Level, Overload, Fault | |||||
Electronic Protection is available. In case of exceeding limits, the load is transferred to bypass without any interruption | |||||
Inverter shuts down automatically | |||||
If the internal Temperature is 90°C the load is transferred to bypass, When it returns < 80°C, Inverter starts to work | |||||
Modem / Network protection input against to Voltage Spikes | |||||
Buzzer, it can be switched off by audible alarm button. | |||||
Battery Mode, Battery Low, UPS fault, Overload, Short Circuit, Over Charge, Charger, Bypass, Inverter fault, Communication fault | |||||
Standart DB 9 (Female) Port, Intelligent RS232 (standard), SNMP(optional) and DB25 parallel port (for paralelling, optional) | |||||
Winpower-XP | |||||
88% | |||||
≤ 55 dBA | ≤ 60 dBA | ||||
EN 61000-4-2 (ESD), 4-3 (RS), 4-4 (EFT), 4-5 (surge), IEC 62040-2 (EMI) | |||||
0 °C ~ 40 °C, maximum 20-90% (Non Condence) | |||||
-20 °C ~ +70 °C | |||||
IP20 | |||||
Forced cooling with variable speed fan according to load % | |||||
≤ 1000 meter (from the sea level), at nominal load | |||||
260x717x570 | |||||
35 / 84 | 38 / 93 | 38.5 | 55 | 55 |
- Q: How many power illuminator can 5Kva 36V transformer drive?
- By formula: P=UI COSAThat is, the transformer capacity is S=UI=5KVAHow big is the COSA?. Look, what kind of illuminator do you use?. Usually take 0.8-0.9It can be calculated that P is about 4KW-4.5KW (general lighting)
- Q: What transformer can be used in a safety voltage lighting transformer?
- 220V/36V or 24V isolation transformer. Double winding, high and low voltage coils, not connected.
- Q: What type of low voltage transformer should be adopted for safety lighting power supply?
- In general, indoor transformers are used in general practice
- Q: Why should lighting transformers be used in factories and mines?
- In some factories and mines (such as power plants), in order to supply power reliability, the power system is grounded in a three-phase, ungrounded, or neutral manner. In this way, the transformer must be connected to a neutral grounding type with a special transformer to supply power to the lighting.
- Q: 1000 square meters low voltage.36 volts lighting power supply with multiple transformers and wires
- First of all, make sure your power is too large, but you are not recommended to do so, the cost is too high, the pressure drop is too large, you can raise the voltage to 220V or higher, and then transfer to avoid power losses. If the direct transmission, the power is slightly larger, the line will be very rough, the cost will be very high
- Q: Is the substation separate from the power and illumination transformer?
- The power and illumination of the substation are all used on a transformer, which is separated by power and lighting by the station screen of this transformer.
- Q: The transformer zero line has broken, has the result to the household illumination circuit?
- No, the zero line of the transformer doesn't go through the zero line of the transformer. It is a star connection, and the center point is zero line
- Q: Line lights, lighting transformers in use!! Can live line work?!! Be afraid of electric shock 40
- General line lights are 36 volts, especially in the damp and harsh environment, the light transformer adopts 24 volts voltage;After the use of light transformers, can generally live operations, first, low voltage, less dangerous, and the two is a transformer isolation, safety is greater, so you can live work, generally there will be no electric shock accident. (as long as the power is not in the hands and hands, the two end of the power supply, there will be no electric shock.)
- Q: How many A leakage protection switches are used in 5000VA lighting transformers?
- Secondary current =5000VA/220=22A, you can select the 32A leakage protection switch.
- Q: How is the lighting power of the 380V transformer calculated?
- Special transformer power transformer (electric furnace transformer, rectifier transformer, power frequency test transformer, voltage regulator, transformer, audio, mine variable frequency transformers, high frequency transformer, transformer, instrument transformer, impact power transformer, reactor, mutual inductor etc.) circuit with T symbol number. For example: T01, T201 etc.
1. Manufacturer Overview
Location | Guangdong,China (Mainland) |
Year Established | 2000 |
Annual Output Value | US$5 Million - US$10 Million |
Main Markets | 10.00% North America 10.00% South America 10.00% Southeast Asia 10.00% Mid East 10.00% Eastern Asia 10.00% Africa 5.00% Eastern Europe 5.00% Western Europe 5.00% Central America 5.00% Northern Europe 5.00% Oceania 5.00% Southern Europe 5.00% South Asia 5.00% Domestic Market |
Company Certifications | ISO 9001:2000;ISO 14001:2004 |
2. Manufacturer Certificates
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability
a) Trade Capacity | |
Nearest Port | Guangzhou |
Export Percentage | 51% - 60% |
No.of Employees in Trade Department | 11-20 People |
Language Spoken: | English, Chinese |
b) Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
10KVA UPS Price with High Quality
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1 Piece pc
- Supply Capability:
- 2000 Pieces per Week pc/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches