Stainless Steel C Clamps

Hot Products

steel pipe fitting /flexible coupling

steel scaffolding pipe clamp fitting

pipe clamps with shaft stainless steel

stainless steel pipe clamp with rubber

suspension clamp for adss cable clamp

high strength german style hose clamp

high quality standard large pipe clamp

pipe clamp m8+10 with epdm rubber pipe

galvanized steel 16mm bandwidth p-clip

stainless steel u-shaped pipe clamps

FAQ

How much can the current clamp measure up to? How much accuracy can be achieved?

The clamp meter maximum gear 1000A. Resolution 0.1A; accuracy + 2.5%+5. For example, the uni-t.

Is the flow meter good or the multimeter?

The multimeter is divided into a pointer multimeter and a digital multimeter according to the display mode. Is a multifunctional measuring instrument, multi range, general multimeter can measure DC current, DC voltage, AC current, AC voltage, resistance and audio level, some parameters can also be measured AC current, capacitance, inductance and semiconductor (such as beta) etc..

A multimeter can measure AC current?

A universal pliers ring table is set to measure current, but a multimeter since called multimeter, not only measured the alternating current of a function.

The digital universal meter can measure the maximum AC current

The biggest I can see is below 20A

How to detect electronic fishing gear?

The other is a direct current clamp type measurement table (see Figure three), general electrician or electronics repair shop has the current clamp type table, the table in the DC gear, the range of current selection must input current electronic fishing device is greater than the measured gear.

Excuse me, great God. What is a DC clamp type?

Clamp meter is composed of a current transformer and current meter assembly. The iron core of the current transformer can be opened when the wrench is tightened; the wire through which the current is measured can be cut through the opening of the iron core without cutting off, and when the wrench is released, the iron core is closed.

My model number is UA9250. Would you like to ask how to distinguish the gears on the following table?! There are no letters on it. Some numbers will do. Please explain

Usage method(1) mechanical zeroing is necessary before measurement(2) select the appropriate range, first select large, then select small range, or see the nameplate value estimation.(3) when the minimum range measurement is used and the reading is not obvious, the number of turns to be measured shall be measured by the number of turns in the center of the jaw, and the readings = indication value * range / full bias * turn number(4) when measuring, the wire should be placed in the center of the jaw and close the jaw so as to reduce the error.(5) after measuring, place the change-over switch at the most measuring range.

How does the 36V transformer change the starting power of the car?

Then the electricity for clamp meter to measure the current, if the battery is charged with a current of 100 ampere 10 or so, if the current is large the 220 volt power supply terminal receives 380 volts, then 220 volt power supply, current will drop, anyway, this transformer can meet your needs. Adjust the voltage until satisfied.