Fsp Sheet Pile

Hot Products

FAQ

How to distinguish cold formed section steel and hot rolled section steel?
Cold-formed steel is a product of various cross sections bent in cold form with steel plates or strips. Cold formed section steel is an economical light section steel, also called cold-formed steel section or cold bending section. Cold-formed steel is the main material for making light steel structures. It has various kinds of super thin and reasonable shapes and complicated sections which can not be produced by hot rolling. Compared with hot-rolled steel, in the same section area, turning radius can be increased by 50 ~ 60%, moment of inertia can be increased 0.5 ~ 3 times, so it can be more reasonable to use the strength of the material; and ordinary steel structure (from traditional I-beam, channel steel and angle steel and steel plate made of steel structure comparison) that can save steel by 30 ~ 50%.
What is special steel?
Agricultural steelAgricultural steel is the main means of agricultural production and agricultural private or semi private steel, mainly are: Farm steel: Farm steel is commonly used steel for rural primary system of small tools and general civil tools. Main is a small section of round steel, flat steel and other varieties of composite steel composite steel billet, billet and hoe sickle knife blank, used in the manufacture of sickle, hoes and other small tools and other tools (such as knife, etc.). This kind of composite steel consists of two same components of the carbon steel hot rolled, low carbon steel is outside the body, soft and tough body steel seismic, good adhesion, easy sandwiching a layer of grinding. Leaf blade steel containing carbon, manganese, hard and wear-resistant, polished production tool edge is very sharp.
What does "M" mean?
M section steel: sectional shape steel like M.
Does the profile include H?
Profiles include section H steelThe online quote H steel and profiles in the angle of groove separate quotation, mainly because H steel has great use compared with the other, and the demand is relatively more, but in some cases, and H type steel I-beam can also substitute for each other.
Elastic modulus of section steel
The elastic modulus of steel is 2.1 * 10^7N/cm L.
Can the section steel butt joint in the end?
Docking is usually available.If welding, it is mainly worried that the welding is not strong and the welding stress is too large. The wall thickness of the section steel is thin, and the butt welding itself is the most unreliable. So, in the joint lining board, fillet welded. Attention is paid to reducing stress in the process.Bolt connection also requires lining plate, pay attention to bolt size, quantity and spacing. To calculate whether thin-walled steel itself will be crushing, the solution is solder paste board, and bolt holes.In short, the principle is that the strength of the butt joint is not weaker than that of other parts, and there is no greater stress.
What are the common types of profiled steel?
Section steel is divided into two types: simple section steel and complex section steel.Simple section steel: steel, wire rod, square steel, flat steel, six angle steel, triangular, elliptical steel, steel arch steel, etc..
What kind of steel is used in steel columns?
The steel sheet pile has various forms, and the sides of the steel sheet and the joint groove are different in shape. The second plate, after the first one is in place, takes the front sheet of the sheet pile and the side notch is used as the driving point. As a result, a plurality of sheet piles may form relatively complete sheet pile walls along the coast (or bank of the river). In addition, a group of steel sheet piles can be used for temporary retaining protection when the foundation pit is excavated or excavated.