Q:What does "D41X-16" mean?

GB case, D is butterfly valve, 4 is flange connection, 1 refers to the midline structure, X is sealed form for three yuan, ethylene propylene rubber seal, and 16 is the pressure of 16 kg.

Q:How does the pneumatic butterfly valve control the angle of opening?

This is really not good, control seems to be pneumatic defects, can only rely on the feeling

Q:Why anti condensation of aluminum alloy anti condensation butterfly valve?

Anti condensation butterfly valve multi-level unique progressive contact seat design, the valve plate in close contact in the process of gradually seat, ensure good sealing performance while reducing unnecessary torque, and the butterfly plate of stainless steel and the inner parts, thereby prolonging the service life of the valve seat, has strong rust and corrosion function. Torque reduction enables the drive to be lightweight and miniaturized. Unique stem seal prevents fluid leakage.

Q:Where are the exhaust valves, mud valves and butterfly valves?

Chemical plant with colloid, puffed agent and granule. Wine industry, paper industry. Butterfly valves are used in petroleum, chemical, food, pharmaceutical, textile, water and electricity, ships, urban water supply and drainage, smelting, and energy systems as regulating and intercepting devices.

Q:Butterfly valve D71X-10 and butterfly D371X-10 what is the difference?

One more 3 in D71X-10 stands for adding a worm gear to the valve. What are the same, the difference is driven by the handle into the drive, gear drive, worm gear drive for large caliber butterfly valve a little less, because the valve torque is big, big, hard to handle and can rotate, and if the worm, you can turn a few laps handwheel. If there are other questions, we can continue to ask questions, the city butterfly valve manufacturers

Q:1st where is my zone valve? I have an old Burnham gas baseboard heater2nd What do I do?My last resort is calling a proffesional.

do mean you have an area in house that the heat isnt working in? if so try by passing the thermostat zone valve is that same as circulator pump its valve in the line to radiator usually near boiler has wires onit that go to thermostat should be a circulator pump for each thermostat

Q:i was changing valve seals and two dropped i can see the head of the valve but a magnet wont pull them up i put air the spark plug hole too but no luck 1985 ford bronco II

Your going to have to pull the heads.

Q:How warm is the PTFE butterfly valve?

PTFE butterfly valve, sealing surface of fluorine plastic, temperature -29 ~ 450 degrees

Q:My bike has now 6200 miles on the odometer. The manual says that a valve adjustment should be performed every 6000 miles. But the bike runs fine. Can I just have the valve checked or should I have them adjusted even though the bike is fine? What will happen if I just keep riding it?

if the valves are not chattering (WOrse then normal) and you havent lost power or gas milage, then no...dont get it adjusted and no ... your not hurting the bike.

Q:Not the cold and hot water shut off valves. The one with a tiny handle and it looks like a T. what does it do? should I mess with it?

Hi There I installed a valve with a t-type handle for my refrigerator's ice maker. This is a saddle type valve which is place on a water line and taps into the water inlet . It has a piece of rubber around the needle valve so it will not leak. If there is no plastic or copper line protruding from the line then it should lead to an ice maker. Now I have seen the same type of valve which was placed on the water line and then hooked up to the dishwater. Either way don't mess with it unless it leaks... Why the pipe it is attached too will have to be replaced. Been there done that check out the two links below