Introduction of Good Quality Different Axis Spring Gun:
Different axis spring gun is the normal option for GRC products spraying by hand; The obvious setting of this kind is to separate the glassfiber cutting from mixture with other materials such as mortar into individual nozzle , easy to adjust the proportion between glassfiber and mortar, achieving the strength standard what GRC products require.
Technical Data Sheet of Good Quality Different Axis Spring Gun:
Air-operated mortar pressure: 0.35-0.45Mpa
Mortar pressure: 0.25-0.35Mpa
Fiber pressure: 0.25-0.35Mpa
Max rotate speed of air-operated motor: 2500r/min
Granule Diameter: < 2mm
Fiber length: 30-60mm
- Q:GRC composite column, which is better?
- Outsiders do not know, professional manufacturers say their good, or goods than three.
- Q:Are there any national standards (strength, protection grade) in the case of GRC materials used as equipment and outdoor rooms?
- Only depending on your equipment, see if there are any special requirements, and then refer to the GRC standard.
- Q:What is the standard value of GRC durability?
- Truly qualified GRC products and its durability is almost the same concrete (generally 50 years), but the domestic nine out of ten GRC are only a few years of life, especially inside the reinforced GRC, think of the strength of the mortar is much clear that the quality of life and what is the fake GRC. Only the alkali resistant fiber (of which two zirconia content is an important index to more than 16%) the content of not less than 4.5% is qualified, and its production process and standard, to dense.
- Q:What is a GRC pile composite foundation?
- By adjusting the amount and proportion of cement, the strength grade varies between C15-C25, which is a kind of pile type between the rigid pile and the flexible pile. CFG pile and soil between piles with the formation of CFG pile composite foundation to work together through the cushion, so it can be based on the behavior of composite foundation and calculation in engineering design. CFG piles generally do not need to calculate the reinforcement, and can also use industrial waste, fly ash and stone debris as admixture, further reducing the cost of the project.
- Q:What about the air leak in the flue?
- There are many kinds of problems. See where they leak.1, if the valve leaks, you need to remove the ceiling to check the valve.2, if the flue leaks, it is necessary to repair the loopholes.
- Q:(GRC) substitute material for plates
- If from the cost point of view, of course, yes, I suggest using EPS bar, but in the middle of the bubble, generally used in low grade buildings. If the GRC project is big, the wide friend GRC can build a temporary factory next to the project, so that it can be installed directly.
- Q:What's the difference between partitions?
- There are many types of partition board, such as partition board raw material is not the same, the product is not the same, such as composite fiber, cement, foam, ceramsite and so on.There are many types of partition board products, such as interior wall panels, exterior wall panels, their length, thickness requirements are not the same.
- Q:What are the features and capabilities of GRC components?
- Exterior wall insulation energy-saving materials, energy-saving materials are thermal insulation materials. An insulating material is a material or material complex used for building enclosure or thermal equipment, and for the transmission of an impedance heat flux. It includes both thermal insulation materials and cold protection materials. The significance of heat insulation material is to satisfy the thermal environment of building space or thermal equipment, and to save energy. With the worldwide energy shortage day by day, the significance of heat insulation materials in energy saving is becoming more and more prominent. As far as the heating of ordinary residents is concerned, the use of thermal insulation materials can save energy on the existing foundation 50%~80%. According to the energy saving practice in Japan, 3 tons per year of standard coal can be saved by using 1 tons of heat insulation material, and the energy saving benefit is 10 times of the material production cost. Therefore, some countries regard thermal insulation material as the fifth largest energy source after coal, oil, natural gas and nuclear power".
- Q:GRC cement products have cracks, what are the reasons?
- Strengthening the maintenance, reducing the hydration heat of cement and controlling the internal temperature of concrete products are effective measures to reduce the cracks on the surface of cement products.
- Q:How many useful years does the GRC art component have?
- Like the GRC component of the general quality of the normal use is 20 years -30 years, like GRC friends of building decoration component of good quality can be used in 50-80, or the old truth, a penny goods, buy cheap GRC components, service life will be discounted.
ARTS, is engaged in environmental art, GRC projects. Our business scope mainly includes: bridge, embankments,garden fence railings, GRC European component,GRC / EPS prefabricated building component and engineering and garden hard landscape etc.
Our company has the capacity of independent mold development and GRC professional equipment manufacture.
1. Manufacturer Overview
|Annual Output Value
||Above US$ 10 Million
||20.00% North America
15.00% South America
15.00% Eastern Europe
10.00% Southeast Asia
10.00% Northern Europe
10.00% South Asia
10.00% Western Europe
5.00% Mid East
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||41% - 50%
|No.of Employees in Trade Department
||Above 150,000 square meters
|No. of Production Lines
||Design Service Offered;
Buyer Label Offered
|Product Price Range