Q:Virtual home 2 kitchen faucet how to repair ah

Pro, the villain dragged to the bottom left corner of the house helium floating reed berry every Feng Tong Queer, is the tool room, and then there will be "Fixingthe (sorry, forget the word)" and then he will own to repair The faucet

Q:I have a single basin faucet. How do I change it into a regular faucet without replacing it?

If you find a way to change it with out replacing it, would you also find a way to change lead into gold ,Please.

Q:With a set of taps on the stone basin

Pure copper polished, you need about sixty yuan.

Q:Are all the faucets the same size?

Commonly used faucet diameter DN15 (also called 4 points), there are caliber DN20 faucet, but rarely used, and then have not seen a large.

Q:Inflatable faucet will save 30% of water, what is inflatable faucet

In fact, in the water part of the addition of a bubbler, you can increase the water bubble content, can play a water-saving, soft splash effect.

Q:I am on the basin of the faucet flow is relatively small, I put the inside of the filter after the filter, installed back, the faucet is not water, and how to do?

In the home into the water mains of the place installed a booster pump it.

Q:A few days ago to the home of the kitchen faucet for a new, but after the change of the problem came, in the faucet and pots connected after the discovery of the tap base and pots connected is not strong, always able to turn, and later found The bottom of the fixed nut is loose, you want to tighten some of the metal gasket are squeezed and can not be fixed (metal gasket is a single hole screw).

In the middle of the two studs with a few large nuts on the tightened

Q:I Just bought a new kohler faucet to replace my old but the hoses on the new ones are short. It has a 3/8 connector and my old one had a 5/8 connector...the old hose is pinched into the shutoff valve tap so i cannot remove it...what can i do to connect the old pipe with the new one...please help....home depot was no help

Here's the bottom line, as I see it. Shut off the water to the house at the service valve out front or, if that valve doesn't work properly, shut it off at the meter. Get a tubing cutter and cut off the service valve under the sink as close to the valve as you can. Do not use a hack saw, use a tubing cutter. Home Depot sells new service valves that are compression fittings to slip over the pipe coming out of the wall or floor. Take the old valve with you so they can help you with the correct size. You'll need to cut off both valves. When you buy the new valves, buy some new armored hoses to connect your new faucet to the new valves. You'll need a couple of wrenches to install the new valves and hoses, and you may need a basin wrench to install the new faucet. Consider the tools an investment and the valves and hoses maintenance expenses. Once you've done one successfully you'll never be intimidated by that type of job again. Good luck.

Q:What is the material for the basin faucet? Please know that friends talk to see.

According to the current understanding of the point of view, copper faucet is very good, such as pine lin basin faucet, on the one hand because copper has good machinability, mobility and formability, and electroplating after the nice, the other is copper ion Has a bactericidal effect, making it the most suitable "water" carrier.

Q:Basin basin faucet and sink faucet with what brand is better?

Hello there! At present the best should be: Kohler. Guaranteed for 50 years