Teflon & PTFE Hose
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 10000m m
- Supply Capability:
- 80000m per month m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Quick Details of Teflon & PTFE Hose:
|
Place of Origin: |
China (Mainland) |
Model Number: |
PTFE Tube |
|
Material: |
PTFE |
Specification: |
customized |
|
Thickness: |
customized |
Standard: |
ISO 9001 |
Specification of Teflon & PTFE Hose:
Teflon Hose has a wide range of practicable temperature from -180C~+260C and a wax -like surface to which anything hardly Hose. Teflon Hose has the lowest coefficient of friction of all known solid materials.
Teflon Hose has the best electrical properties of all plastic hose. Use of the Teflon Hose The electrical insulation used u
nder various kinds of frequency, the seal liner of various kinds of corrosivity medium, Antisticking materials, lubrication material.
The Technical Parameter of Teflon & PTFE Hose:
|
Project Name |
Unit |
Result |
|
Tensile Strength |
Mpa |
14.0 |
|
Ultimate Elongation |
% |
150 |
|
Wall-Thick( mm ) |
0.4, 0.5, 0.6, 1, 1.2, 1.5, 2, 3, 4, 5, 6, 7, 8, 9, 10, 12, 14 ... 40, 50mm | |
|
OD ( mm ) |
1.2mm, 1.4mm, 1.5mm, 1.6mm, 1.8mm, 2.0mm, 2.2mm, 2.4mm, 2.5mm, 2.8mm, 3.0mm, 3.2mm, 3.5mm, 3.8mm, 4.0mm .... 10mm | |
|
length ( mm ) |
5m, 10m, 20m, 25m, 50m ... 100m, 200m | |
Packaging & Delivery
|
Packaging Detail: |
plastic film |
|
Delivery Detail: |
80000M within 20 days |
- Q: Rubber soft joint, what brand of good, the best price is more reasonable. Don't say anything expensive.
- The rubber joints produced throughout the country have the longest history in Shanghai, and have the characteristics of the type and sales volume of Gongyi city. They have been sold in the plumbing market all over the country
- Q: Can black soft rubber pipes be used as water pipes? Why is there a pungent odor?
- Black rubber hose is not suitable for water pipes, black rubber tube, or all the use of recycled rubber is very high; and black rubber tube is generally industrial use.
- Q: Why should the high pressure hydraulic tube peel off the outer skin?
- Skinning requirement:The stripping length of hydraulic hose shall be two to four mm shorter than the caseA layer without peeling, more than two layers stripped to see the steel wire, otherwise the shell is easy to fall offThe size of the joints to be installed depends on the size of the joint and the quality of the hose, just start recording more to find the most suitable size.
- Q: Can the high-pressure rubber hose be followed by water pipes? Will it be poisonous?
- High pressure rubber tube adhesive for synthetic rubber, is generally not recommended for civil water, if it is regular water
- Q: Water heater hose 4 points and 6 points difference
- 4, in charge of and 6 in charge, from the caliber is obvious to see out, 6 in charge of greater than 4 in charge. Inside diameter 4 inches, have 13.2 millimeter about, 6 inches are 19.8 millimeter, 6 inches of pipe than 4 inches big. 6 points in diameter 1.6cm, 4 points in diameter 1.2cm, see thickness can be distinguished, 4 branch pipe diameter is 20mm, and 6 points water pipe diameter is 25mm, general heating with 6 points, slightly thick. The tap water is 4 inches fine.
- Q: The use of anti slip rubber joints under what circumstances?
- The flange connecting the rubber joint shall be the valve flange or the flange conforming to GB/T9115.1 (RF).
- Q: What are the main differences between stainless steel flexible joint and rubber soft joint?
- The same specifications of soft connection, the price is almost the same. If there are no special requirements for length and environmental protection, rubber connections can be selected.
- Q: How to replace natural gas hose? Steps?
- Replace the natural gas hose first pressure relief, and resolutely put an end to the operation with pressure;According to the connection way of the hose, if it is O ring sealed, just tighten it directly;If it is cone thread, it can be wrapped with raw material tape or sealant.
- Q: The gas water heater uses metal pipes and rubber pipes
- Rubber tube will be aging for long time, it is better to use gas special stainless steel bellows
- Q: Excuse me, how can I get waterproof wires in the water?
- 35kV and below in low voltage cable joints if needed in the operation of the water environment, please do waterproof seal in the joints, joint can be orderly wound waterproof tape, heat shrinkable tube ends after heat shrinkable pipe shrinkage sealant, waterproof seal, installation conditions outside the FRP shell, shell insulation waterproof sealing glue perfusion. If the ordinary rain prevention, joints at both ends of the sealant after the root shrink heat shrinkable tube, heat shrinkable pipe mouth, waterproof belt, +PVC belt sealed!
1. Manufacturer Overview
| Location | Tianjin, China |
| Year Established | 1998 |
| Annual Output Value | Above US$ 2 Million |
| Main Markets | Mid East, Africa, Europe, America |
| Company Certifications | ISO 9001:2008； |
2. Manufacturer Certificates
| a) Certification Name | |
| Range | |
| Reference | |
| Validity Period |
3. Manufacturer Capability
| a) Trade Capacity | |
| Nearest Port | Tianjin; Qingdao |
| Export Percentage | 50% |
| No.of Employees in Trade Department | 300 People |
| Language Spoken: | English; Chinese; Spain; Alabic |
| b) Factory Information | |
| Factory Size: | Above 20,000 square meters |
| No. of Production Lines | 4 |
| Contract Manufacturing | OEM Service Offered; Design Service Offered |
| Product Price Range | Average |
Send your message to us
Teflon & PTFE Hose
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 10000m m
- Supply Capability:
- 80000m per month m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
