Q:The maximum number of joints for a rubber hose is no more than

Shower hose, shower hose, two joints are nominal diameter of: 1/2 inch (4 thiophene) cylindrical pipe thread. Standard component. Hot and cold bath: take a bath with hot water before going to bed every day. The temperature of the water is within the limits of the body's tolerance. After washing, sleep in hot water for 15 minutes. After bathing was out of a sweat, after 3~4 minutes, and then into a basin of cold water or cold shower. Note that the hot and cold bath must be "hot before cold."".

Q:Can the rubber hose for the LPG cooker and gas cooker be general?

However, attention should be paid to the isolation of fire sources during storage and transportation, avoiding the exposure of sharp instruments and more corrosive chemicals, and avoiding prolonged storage in daylight.

Q:What are the properties of stainless steel metal hose materials?

Stainless steel metal hose material is generally 304 stainless steel, the material of good ductility, flexibility, corrosion resistance, high temperature resistance.

Q:What with the appropriate suction tube Dichotomanthes tube and rubber machine

The bellows are extruded by the extruder, and the winding tubes are wound in circles

Q:Can the natural gas hose not exceed 1.5 meters or 2 meters?

If the gas is longer, to Caution! Protective tube wall, as far as possible, to prevent accidental damage risk of gas pipe.

Q:How can the rubber pipe leaking from the cold water inlet of the electric water heater do?

Estimation is inside the pipe aging cracking due to Water Leakage, no maintenance necessary, unless it is a joint sealing ring in aging can replace the sealing ring of new or with rubber or other flexible items I cut a replacement.

Q:The difference between hose and rubber tube

Rubber tube: characteristics of rubber tube has physiological inertia, UV resistance, ozone resistance, resistance to high temperature (-80 to 300), high transparency, strong resilience, resistant to compression permanent deformation, oil resistance, impact resistance, acid and alkali resistance, wear resistance, flame resistance, voltage, conductive properties. In fact, silicone hose is also a rubber tube, resistant to oil, heat.

Q:The principle of the common bicycle valve

An elastic thin edge hose is placed below to form the whole of the core. In fact, it is a one-way valve. When inflating the bicycle tyre, the compressed air in the air pump enters the valve core from the hollow part, and the elastic rubber tube is top, and the air enters the tyre.

Q:What about leakage of hose joint?

First, the water source is cut off, then the male and female nuts which are connected with the compression joint are removed, and a plurality of threads are screwed on the thread to seal the rubberized fabric, and then the connector is re assembled.

Q:Latex tube, rubber tube, silicone tube, which three of the best tightness?

Ding Ji rubber: usually used as a silicone hose material used, in general, the sealing ability of silicone hose is better than the rubber hose. So, in life or in the industry need to seal the tube will take into account the silicone hose.