Q:Hydraulic forklift truck classification

Hydraulic manual push high car, TF type hydraulic platform, cotangent cylinder, electric platform car, semi-electric drive, WAWP hydraulic forklift truck. Electric walking, hydraulic lift; It is light weight, low body, light operation and wide view. The frame design is strong and the bearing capacity is strong. It is stable, the electromagnetic braking of the motor output shaft. Large capacity traction battery to ensure long working hours. Electric drive, electric lift; It is easy to operate and has broad vision. The frame is strong and the bearing capacity is strong. It runs in a balanced way. Large capacity traction battery to ensure long working hours.

Q:Basic requirements for forklift operation

No man on the fork, no man shall be allowed to operate on a forklift truck Be careful to handle large items, and do not carry unsecured or loose goods Check the electrolyte regularly and prohibit the use of bright fire lighting to check battery electrolyte Before you stop, place the fork down on the ground and put the forklift in order, stop and turn off the car When the power supply is insufficient, the power protection device of forklift will be automatically opened, and the forklift fork will refuse to go up and continue to carry the cargo

Q:How to tell the truth from a forklift?

Click on "special equipment management" section; On the right, you will see a "operator" under the "integrated query" section. Click "operator" to enter the "national special equipment practitioner information query system"; Enter the query system to click the "operator query" entry, enter 3 items: name, id number, forklift card number, according to the query.

Q:People leave the forklift and do what and what to pay attention to when parking

Before leaving the forklift, remove the cargo fork completely, hold the hand brake and remove the key of the switch. Press the emergency isolation switch. If you park the forklift on a slope, you must plug the wheels.

Q:The photo of the forklift card is a few inches. Is it colorful?

I am a forklift driver training, as long as one inch of color picture is ok, the free crown, do not need blue bottom

Q:The forklift truck is a motor vehicle solution

It's a motor vehicle. It is only used for loading and unloading, and it is usually only in the factory area. All motor vehicles must be listed. Of course individual drive a factory to need to use forklift truck general is not to go up the list.

Q:How does the fork of a forklift know that there is no balance

There are two kinds of fork balances, one is empty and one is heavy. Empty balance: flat. Stop when the fork is placed a few centimeters off the ground. Eyemeasure or measure, the tip of the cargo fork is separated from the ground. Can be measured.

Q:A manual forklift oil leak, what if you can't get up?

Internal leakage (1) there is too much friction between the stem and the valve body Multiple directional control valve hoisting and tilt on the stem of each have three groove, groove and oil that can be switched on or off oil, change the way to work. Good distributing valve clearance between the valve stem and valve body is small, the spill is few, so the hydraulic cylinder down or tilt volume is small, do not affect work. But when wear clearance is too large, under the pressure of the hydraulic oil pump at work to produce, can cause work in oil or oil spill oil and the oil return tao, automatic back to the tank. The reason is mainly, because of the distributing valve use for a long time or the oil not clean accelerated wear of valve stem and valve body, such as destroy the sealing surface, lead to the oil. Repair if stem wear lighter, when to stem chrome plated finish; If the stem is worn badly, it needs to be replaced.

Q:Which is better, solid forklift tyres and inflatable forklift tyres?

The advantages of pneumatic tyre of forklift truck: easy to install and use of forklift drivers are less affected by turbulence. The price is also cheaper, the drawback: the service life is much inferior to the solid tire, if it meets the hardware factory, the spring It is very easy to break a tyre in the factory and so on

Q:What's the matter with forklift

The problem for many reasons, first, eliminate steering wheel tire pressure is enough, the second, multi-channel valve diverter valve plug lead to the hydraulic oil cannot enter the redirector, wash can solve the diverter valve will be removed, third, the steering gear is damaged, the second reason is that the likely, hope can solve your problem, I am the heli forklift