Q:Boring machine rotation center how to find

Cleared, and then out of the table, rotated 180 degrees, and then open, the dial indicator in the spindle or measuring rod access to zero.

Q:Boring machine boring how to adjust the knife

First fine boring knife with the top wire gently top, and then put down the spindle until the knife on the hole to see the depth of the scratches, shallow, fixed blade after a knife, into the 5 mm when the amount of time,

Q:T68 boring machine works

when pressed down high speed. By the contactor KM6 and KM7 to achieve stator winding from the triangular connection into a double star connection. (2) the main motor can be reversed, jog and reverse brake.

Q:The detailed heat treatment process of boring bar made of 38CrMoAl steel boring machine

Quality (the workpiece to obtain a comprehensive mechanical properties, quenching and tempering generally take 28-30HRC) - fine car to wear the amount of (each side of the single-sided are retained 0.2-0.25mm) - pliers milling milling line - milling tail and related holes

Q:Plan table-type CNC boring and milling machine and horizontal CNC boring and milling machine What is the difference

If strictly speaking, horizontal and planing desktop is not contradictory, planing desktop is horizontal, but the horizontal is not necessarily the form of planing.

Q:The general boring machine can handle the aperture range is how much ah

hole deep hole plus tailstock 300 mm no problem, as long as the table does not exceed the load ,

Q:Do you know how to boring and milling machine clamping method?

Drilling holes in the larger parts of the drill hole, the workpiece can be directly clamped on the work surface, the use of pressure plate bolts clamping the workpiece.

Q:Zhongjie boring machine table and column is not vertical, the accuracy of the deviation, how to adjust?

If there is a deviation between the need to adjust the adjustment of the column around the horn to adjust, depending on the measured value up and down, here pay attention to the accuracy of a lot of columns, the vertical direction is generally two directions AB can not only consider one direction, but also combined

Q:What is the difference between a lathe and a milling machine?

Lathes are generally processing shaft, sets of categories, discs, mats and other parts, usually horizontal horizontal lathe-based, of course, large-scale lathes are also vertical and other forms, lathes are generally knife, used in accordance with the tool,

Q:What is the difference between the main process of horizontal boring machine and coordinate boring machine? What is the difference between the boring machine and the drilling process?

Boring machine hole spacing 0.02mm less than the drilling hole spacing 0.1mm