Q:Method for connecting glass tube and rubber tube

Just one end of the glass, wet with water, and then rotate hard

Q:Excuse me, how can I get waterproof wires in the water?

35kV and below in low voltage cable joints if needed in the operation of the water environment, please do waterproof seal in the joints, joint can be orderly wound waterproof tape, heat shrinkable tube ends after heat shrinkable pipe shrinkage sealant, waterproof seal, installation conditions outside the FRP shell, shell insulation waterproof sealing glue perfusion. If the ordinary rain prevention, joints at both ends of the sealant after the root shrink heat shrinkable tube, heat shrinkable pipe mouth, waterproof belt, +PVC belt sealed!

Q:Will the outside of the brake hose of the car burst apart?

If the brake oil pipe (you should be the brake hose) is best, I'd recommend replacing him

Q:Why should the high pressure hydraulic tube peel off the outer skin?

Skinning requirement:The stripping length of hydraulic hose shall be two to four mm shorter than the caseA layer without peeling, more than two layers stripped to see the steel wire, otherwise the shell is easy to fall offThe size of the joints to be installed depends on the size of the joint and the quality of the hose, just start recording more to find the most suitable size.

Q:Why should liquefied petroleum gas use strong rubber hose and liner?

Commonly called liquefied petroleum gasMain ingredients: ethylene, ethane, propane, propylene, butane, butene, etc. (oil resistance will accelerate swelling and aging).Appearance and properties: colorless gas or yellow brown oily liquid, has a special odor.In order to remind people of the leakage of liquefied petroleum gas in a timely manner, the processing plant often mixes a small amount of foul odor mercaptan or thioether compounds into liquefied petroleum gas, which is the source of special odor.These gases on the rubber has a certain corrosion, swelling (not resistant to oil will speed up swelling), aging effect, liquefied petroleum, so choose rubber seal to consider oil resistance, corrosion resistance, swelling!

Q:Automotive applications of rubber hose

Each kind of rubber has its characteristic, therefore is specially important in the hose material selection. Basically the high-end cars use materials is relatively good, some poor materials using mini car, van, car and as some in the use of nitrile rubber as fuel tube, nitrile rubber are not suitable for fuel system. Thus, the substitution of epichlorohydrin rubber fluorine rubber hose is relatively extensive.

Q:Is the metal hose the same as the soft connection?

Some places are a term, but there are also soft connections, non-metallic soft connections, metal soft connections, so it's better to ask what you want

Q:The gas water heater uses metal pipes and rubber pipes

Rubber tube will be aging for long time, it is better to use gas special stainless steel bellows

Q:Between the two flanges in the middle of the rubber tube, what is the name of the connection?

Rubber flexible joint is also called rubber flexible joint, flexible rubber joint, flexible rubber joint, rubber shock absorber and so on.

Q:Can high speed air flow through a rubber tube and produce static electricity?

It is not easy to describe the magnitude of the voltage generated by the static electricity of these aggregates, which is related to the humidity, velocity, characteristics of the rubber material, and the surrounding environment.