Introduction of Best Quality High Shear Mixer:
High shear mixer is a requisite for GRC production. It has adopted the double-end electric motor for balance and pneumatic to control going up and down. It has many advantages, such as mix speed is very quick(within 2-5 minutes), the operation is stable, materials adhered on the big vane which is few and easy to check up and operate etc.
Advantages of Best Quality High Shear Mixer:
High efficiency, 30-45 seconds for one barrel.
Unique design in impeller, solve the problem of balance.
Highly reduce the rotary speed of mortar, because of notch effect and thinner blade(4mm).
Strengthen radial flow of mortar, increase mixing ability.
Take full of shift gears, mix premix mortar.
Rhombic blade is the most abrasive part in mixer. we use fabricated blade, no need to replace the blade.
Lower electric consumption, 50% less than imported machine.
Data Sheet of Best Quality High Shear Mixer:
Electric source: 380V,
Air supply: flow: 0.125m /minute
- Q:GRC how should the lines be fixed?
- Accordingly. What project quantity sets what quota, find the amount of project quota that you need first.
- Q:What is the difference between GRC wallboard and aerated block wall?
- GRC composite wall board with low alkalinity cement mortar material, alkali resistant glass fiber as reinforcing material, made of plate surface layer, built of reinforced concrete rib, and the thermal insulation material is filled in the core, the new light composite wallboard made of a pedestal.
- Q:What are lightweight partitions and lightweight partition materials?
- Fiber reinforced low alkalinity cement construction slab. The standard specifies the classification, raw materials, technical requirements, test methods, inspection rules, packaging, marking, transportation and storage of cement reinforced and low alkalinity cement construction slabs. This standard applies to asbestos, short to alkali glass fiber or alkali resistant glass fiber as reinforcing material, with low alkalinity sulphoaluminate cement as cementing material for plate. Fiber reinforced low alkalinity cement construction slab is mainly used in indoor non load bearing inner partition temples and ceiling panels.
- Q:What is a GRC pile composite foundation?
- The composite foundation is that natural foundation soil in the foundation treatment in the process of enhancement, or replacement, or reinforcement materials in natural foundation, the reinforcement area is composed of a base (natural foundation soil or improved natural soil) and reinforced artificial base consisting of two part. In the case of load, the matrix and the reinforcement share the load. According to the composite foundation load transfer mechanism of the composite foundation is divided into vertical reinforcement composite foundation and composite foundation level to strengthen the two class, and the vertical reinforcement composite foundation is divided into discrete material pile composite foundation and flexible pile composite foundation and rigid pile composite foundation three.
- Q:What about the air leak in the flue?
- When you want to see what kind of flue air leakage, the division of the usual general exhaust flue or kitchen flue, if the kitchen smoke exhaust, air leakage will be repaired immediately. To make, it is not can replace the exhaust pipe.
- Q:Kitchen, toilet, GRC exhaust channel and glass magnesium plate exhaust duct advantages and disadvantages, and cost performance comparison?
- GRC light material exhaust flue defects:1, the process of artificial prefabrication is prone to uneven wall thickness of the finished product, resulting in low strength of the flue pipe, brittle, and flexible, shock resistance is not up to standard.2, artificial prefabricated smoke exhaust Road, low fire resistance, fire prevention is not up to standard, extremely safe and fire hazard.
- Q:(GRC) substitute material for plates
- GRC component is a new type of exterior wall decoration material. It has glass fiber. It has the advantages of safety, hardness, alkali resistance and corrosion resistance. Why should we instead of material instead?.
- Q:Boiler flue cleaning with hydraulic or mechanical cleaning?
- Mechanical cleaning is possible without damaging the boiler flue.
- Q:GRC light partition board installation scheme for construction of hydropower pipelines
- GRC lightweight partition board is a new type of wall material developed in recent years. It can eliminate longitudinal cracks as long as it is built according to the order of requirement and new technology of interlocking joint is applied. Therefore, GRC lightweight partition board is one of the ideal materials for building energy conservation and wall reform, and has been widely used in engineering.
- Q:GRC cement products have cracks, what are the reasons?
- Strengthening the maintenance, reducing the hydration heat of cement and controlling the internal temperature of concrete products are effective measures to reduce the cracks on the surface of cement products.
ARTFUL, a well-known enterprise which is engaged in the research, development, design, production and sales of high-quality, high-grade GRC decorative, gardening, art sculptures.
Our products include: flower pots, fountains, gazebos, relief paintings, murals, picture frames, stylobate, furniture, fireplace, Roman, corbels, window cover, door pockets, line, figure sculpture statue etc.
1. Manufacturer Overview
|Annual Output Value
||Above US$ 10 Million
||20.00% North America
20.00% South America
10.00% Eastern Europe
10.00% Southeast Asia
10.00% Northern Europe
10.00% South Asia
10.00% Western Europe
5.00% Mid East
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||31% - 40%
|No.of Employees in Trade Department
||Above 26,000 square meters
|No. of Production Lines
||Design Service Offered;
Buyer Label Offered
|Product Price Range