C250 Aluminum Cast Tooling Plate

Hot Products

Casting Ductile Iron Manhole Cover C250 and B125 for Mining with Frames of good quality

Slag Pots for Steelmaking Production / Steel Slag Processing

ductile iron manhole covers with high quality made in China

EN 214 ductile iron manhole covers with high quality in Hebei

EN 214 ductile iron manhole covers of high quality in Hebei Province

Various Capacity & Competitive Price Slag Pot for Steel Industtry

EN 214 ductile iron manhole covers with high quality in Hebei

casted ductile iron manhole cover for mining EN124 Standards Made in China

Slag Pot with Large Capacity Factory Price for Metallurgical Industry

casting ductile iron manhole covers for mining and industry EN124 Standards Made in Hebei

FAQ

What is normalizing, annealing, tempering, quenching? What is the difference between forging parts and casting parts?

For the nodular cast iron, the hardness, strength and wear resistance are improved, such as used in the manufacture of automobile, tractor, diesel engine crankshaft, connecting rod and other important parts. A normalizing and hypereutectoid ball annealing before, can eliminate the mesh two cementite spheroidizing annealing, to ensure that all spheres of cementite. Annealing is a metal heat treatment process, which means the metal is slowly heated to a certain temperature, sufficient for a long time, and then cooled at an appropriate speed. The purpose is to reduce hardness, improve machinability, eliminate residual stress, stabilize size, reduce deformation and crack tendency, refine grain, adjust microstructure and eliminate tissue defects. Its purpose: (1) reduce hardness and improve machinability; (2) eliminate residual stress, stabilize size, reduce deformation and crack tendency; (3) refine grain, adjust microstructure and eliminate tissue defects. In production, annealing process is widely used.

ZGMn13 casting parts processing, with what knife head good?

The ZGMn13 itself is not have processing, if only the processing point, sharpening, ordinary can, if the processing area is relatively large, ZGMn13 external impact load is bigger,

How to calculate the price of casting parts?

According to the complexity of the workpiece, material and casting requirements and process yield

How can the casting be quenched and tempered?

Another is the result of pre heat treatment (quenching or annealing) after quenching and tempering treatment, suitable for ZG35SiMNMo, ZG35CrMo and so on. Please tell the casting process is your product and material and then set tempered.: shutup:

Heat treatment process and purpose of casting parts

Objective: to stabilize tissues, eliminate or substantially reduce internal stress.

How do you mark it on the drawing? Do you need to discuss it with the manufacturer?Because the casting allowance is the standard, then, after all, is the theoretical value, the actual level depends on the manufacturer, so is it necessary to ask the manufacturer?

The general foundry casting technology division will mark put shrinkage and the allowance of the map in your chart (usually with the red pen) for the production of wood or other material wood workers die drawings.

When there is no flaw detection for large casting parts, is there any crack inside?

Cracks are considered serious levels of defects and should be repaired

What's the cause of the choking of the casting?,

3. when casting the environment is humid, sand mold has not removed the moisture, when the casting, the moisture instantaneous transforms into the steam, causes the blowhole