Lights For Swimming Pool

Hot Products

CQB series fluorine plastic magnetic pump

CDL Series Stainless Steel Vertical Multistage Centrifugal Water Pump

QJ Vertical Deep Well Submersible Centrifugal Water Pumps

DC Solar Water Pumps for Irrigation Purpose

S Type anti-corrosive fiberglass centrifugal pump

CHL/CHLF(T) Horizontal Multistage Stainless Steel Water Centrifugal Pumps

Stainless Steel Vertical Multistage Centrifugal Water Pump

CDL and CDLF(T) Series Stainless Steel Vertical Multistage Pumps

DC Solar Water Pump for Irrigation Purpose

DCQB series of low-speed fluorine plastic magnetic pump

FAQ

How can the submersible pump level meter be connected?

Installation of submersible pumps dedicated liquid level float, connected to the submersible pump power line (some submersible pumps bought with), or received submersible pump control circuit, high starting, low stop.

How does the centrifugal pump pump and cut the pump?

Check the motor, pump and fasteners in good condition; whether the lubricant is added or not;Disc dynamic coupling, whether or not stuck phenomenon;Open the inlet valve, remove the gas in the pump or pump the gas out of the pump;

What does centrifugal pump mean horizontally?

Centrifugal pump: centrifugal pump is a centrifugal force on the impeller rotates to transport liquid pump. Centrifugal pumps use the impeller to rotate and cause centrifugal motion of the water to work. The pump before starting to pump shell and the water pipe filled with water, and then start the motor, the pump shaft to drive the impeller and water do high-speed rotation, centrifugal water movement, was thrown to the outer edge of the impeller, the pressure water pipeline flow through the volute pump into the pump shell.

What are the internal losses in centrifugal pumps? How did they come about?

Volume loss: loss due to leakage;3. mechanical loss

Brief description of centrifugal pump on / off operation

Two, centrifugal pump start(1) the pump entrance valve fully open, start motor, outlet valve fully closed, fully check operation of pump.(2) when the pump outlet pressure is higher than the operation pressure, the outlet valve is gradually opened to control the flow and pressure of the pump.(3) check whether the motor current is within the rated value, such as the pump in the rated flow operation, and the motor overload should stop the pump inspection.

Fire hydrant pump button, under what circumstances do not need to install?

The installation of hydrant pump buttons depends on the type of water supply:(1) municipal water supply; (in this case, do not have to install)(2) there is a fire pump; (must be installed)

What are the ways of hydraulic pumps?

Hydraulic pump is a power component of hydraulic system. It is driven by an engine or an electric motor. It draws oil from the hydraulic tank to form a component of the pressure oil which is sent to the actuating element.

What does "dual purpose" of water pump mean? Please expert advice

1, if the water pump in the process of a strong vibration, then must stop to check what is the cause, otherwise it will cause damage to the water pump.3, when the pump valve Water Leakage, some people will fill with dry soil to the water pump inlet pipe, the water washed in the end valve, this is indeed undesirable. Because when the dry soil into the inlet pipe, when the pump started to work, these dry soil will enter the pump, then it will damage the pump impeller and bearings, thus shortening the service life of the pump. When the valve Water Leakage must take to repair, if it is serious that need to replace the new.