Okorder.com is a professional Grp Frp supplier & manufacturer, offers integrated one-stop services including real-time quoting and online cargo tracking. We are funded by CNBM Group, a Fortune 500 enterprise and the largest Grp Frp firm in China.
You wont loose power, you wont gain alot unless you also go with a high flow intake. or change your heads or cam or something else to change how much air moves through the engine. Do it if you want the sound.s
There are two types of dye powder and liquid. I strongly recommend the brand named RIT. One bottle of liquid dyes 2lbs. of dry fabric. follow the detailed instructions on package. As long as the fabric to be dyed is not 100% polyester or 100%acrylic you will have great results. wash your dyed items alone for short time or with just like colors so you don't get dye fade on other cloths.s
Get some type of bottle to dispense the dye. A good idea would be to use something like a mustard or ketchup bottle like you would find in some restaraunts. You want something just like that, only maybe a little smaller. Get a white T-shirt and wet it. Wring it out pretty good, so it is damp. Lay it out on a flat surface. Put your finger in an area around the middle. That will be the circle of your spiral. Leaving your finger in the middle of the shirt, begin to wind the shirt around your finger, making sure the shirt stays relatively flat. Continue to do that until you get it all wound up. It should be about as tall as a doorknob, and the diameter relatively close to that of a saucer. Put three to four rubber bands around it. You should space them out relatively evenly, so it sort of looks like a pie. Fill up your sink with just enough water so that the shirt can be fully submerged. Pour a good bit of soda ash into the water. Not a ton, but a decent amount. Mix it in with the water fairly well. Let the shirt soak in that for about 20-25 minutes. When the 20 minutes are up, wring the shirt out fairly well. Do not rinse. When you put the colors in, you want add enough so you don't see white. You don't want to put so much in that there are little puddles lying around on the shirt. Make sure you get into all the little folds of the shirt. For each section (the little things that look like slices of pie), alternate colors. You could also mix colors, like blue and yellow. Get some plastic wrap or something and cover your shirt for 24 hours. After 24 hours, run water over the shirt until the water dripping out is farily clear. Then you can cut the rubber bands off to see what it looks like. Directly after rinsing, throw just the shirt into the washer with warm water. Use liquid soap. After the wash, just throw it into the dryer for about 20 minutes.s
1., new sewing clean clothes can be washed directly, and recovered through the clean work clothes found oil, should be carefully removed oil, and then wash procedures.To check for damage and abrasion, buckle and other accessories with 2. washing before the defect to repair, replacement or scrap.s