Blue Led Pool Light Bulb

Hot Products

FAQ

LED underwater lamp features of LED underwater lamp
Because of the particularity of underwater lantern application, it is an underwater electrical appliance, so it has the special requirements of its technical specifications.First, underwater lantern protection indicators
LED how many protection levels does the underwater lamp have?
Protection grade of concrete, is the need to test the side can draw the conclusion that the common LED is divided into IP20, IP40, IP65, IP68, if LED underwater lights, at least to just above IP65, IP higher level of security, if the product quality is good, IP65 can meet the.
How can the underwater lamp be buried in the pipeline?
Safety should be repeated grounding, remember to use the leakage of short circuit protector.
How to arrange and install a fountain lamp?
Is second, the fountain lamp placed in the lamp bracket on the bottom of the fountain, rubber cable room (cable ring spring shape reservation), is out of the water in the length of this lamp change, take down from the bracket surface can change the lights,
LED what's wrong with the underwater light?
Waterproof when installingSometimes customers say that the lights are broken, and in the field inspection, it is found that some of the wire skin has been obvious water.
Installation method of underwater lamp and matters needing attention
First of all, for lamp type selection, we should pay attention to the water resistance of the lamp, the power supply voltage and the power consumption of the single lamp
What are the components of the LED underwater light source?
Whether it is installed (scaffolding underwater lamp) or installation (embedded underwater lamp) should be reserved for cable 0.6-1 meters long, to avoid future lighting problems, need to drain the water in the pool, so even if the lamp is broken, water from the lamp can be put on the surface of the water to mention doing waterproof treatment with changing connection and wiring
How to do waterproof treatment for underwater lamp joint?
After filling the waterproof and filling adhesive, the outer layer of the filling rubber is wound with a self adhered waterproof adhesive tape or stretched with self adhered waterproof adhesive tape to wrap the multi-layer, but the thickness is not too thick, so as not to be too large, and the insulating sleeve is not allowed to enter.