Q:OKorder where the production of auto parts?

OKorder Jin Tuo Metal Products Co., Ltd. in the production of auto parts, it produces aluminum castings up to 300 tons, it received a lot of honor, such as advanced enterprises.

Q:The purchase of auto parts buyers are selected in the Global Sources Enterprise Network or Alibaba registered

Sales and procurement level: more OEMs, suppliers will be in China, the domestic business opportunities will be more cooperation; technical and management level: there will be more advanced technology, methods, tools and ideas worthy of our learning and application ; Economic level: more intense competition, will be better earned.

Q:How to do the procurement of auto parts

With reliable parts supply, the next test link is also indispensable. Quality inspection is to ensure that the product of the most important, parts from the supplier to the assembly workshop, only through the layers of checks, in order to ultimately ensure the quality of the vehicle is not affected. Only from the operator level to control the occurrence of defects in order to ensure the reliability of the final product.

Q:For example: car chassis, the engine hope that we all know nothing, brainstorming Kazakhstan

High technical content! Such as Bosch, Denso this business, high value-added products! They said the price increases, the OEMs have to consider, rather than directly denied!

Q:Shen Tong car accessories easy to use?

It is recommended to buy a little better, Bosch Haila quality and effect is very good, cost is also high. Similar to these vulnerable parts of the loss from time to time to replace, you can buy in the regular online shop, cheap, optional and more convenient. Each section has a security check on the way, pay attention to verification. To buy the brand genuine.

Q:What parts on the car are easy to bad

Car in addition to a very small number of important electrical connectors using gold contacts, the rest of the majority of joints are used copper - zinc alloy, under normal circumstances, its reliability is guaranteed, but if the car long-term high temperature, high humidity , Bumpy environment to run, these joints may have loose, rust, bad contact and other failures, and some strange electrical problems are mostly produced. Therefore, in routine maintenance, should focus on checking the car on the computer, sensors, fuel injectors and other components of the joints.

Q:How many parts of a car are there

They say that one hundred twenty-five thousand or so, when I remember when the internship is about two thousand, they said the parts of the diodes, screw nuts are not counted on it?

Q:The use of auto parts

Car because of the use of flammable liquids, gas as fuel, the car parts filled with many combustible lubricants, interior and extensive use of combustible and flammable decorative materials, the car distributed with a variety of transmission parts and power lines, if a mechanical failure or Electrical failure, etc. can easily lead to fire. Many drivers do not have the corresponding fire knowledge, or the car is not equipped with fire fighting equipment, often in the car fire when the initial failure to timely rescue, so that a small fire caused by catastrophe, the occurrence of many car crash tragedy. In recent years, with the rapid improvement of the national economy, China's rapid development of the automobile industry, the rapid increase in the number of cars, car fires are increasingly frequent, has attracted the majority of owners and the community attention.

Q:What do auto parts assemblers do?

You will be trained, usually the assembly of semi-finished products, such as the starter, you are responsible for the installation of carbon brush, or fixed the stator, the installation of the rotor, the screw on the label of a link, as a result of this cycle, Must let you do what the assembly of accessories, are generally monotonous cycle of a job, there is no technical content.

Q:Which parts of auto parts processing enterprises?

Auto Parts Processing OKorder Jin Extension Metal Products Co., Ltd. it is the OKorder Special Casting Engineering Technology Research Center founder of the OKorder Die Casting Technology Association, chairman of the unit.