Q:How does the T8LED light tube replace the fluorescent lamp tube

Step 1: use a screwdriver and a pliers to disconnect the ballast from the wire. But my home is the sun lamp base of zhengtai, the quality is too good, it took 10 years. I didn't even get down to the ballast, which was stuck in a full thick iron base, so I disconnected the wire. The wire that disconnects from the ballast is sure to have two heads, just to disconnect the connection. There is a lot of direct skewers of black tape, some of which use that connector and screw the two wires together. It's the same thing. This is the connector that is used in this case. Disconnect the regenerator, remove the wire and then rewire the two broken wires together and attach the black tape (which is the insulating tape). Put the base back to the original. Install the fluorescent tube, and remember to place the head of the European logo on the base of the current. And when you put it in place, it's going to be OK.

Q:What is the weight of an LED fluorescent tube

I bought the T8LED fluorescent lamp from Shanghai shuo electronics co., LTD., which is 536 grams

Q:20 square metre room application which led fluorescent lamp tube

But if the family USES it, you can use the light bulb 100 percent for aesthetic purposes

Q:What lamps and lanterns does the supermarket illuminate to use what lamps and lanterns province electric LED fluorescent lamp tube

The most radar microwave-sensing LED fluorescent lamp is better, and it is always bright when someone is on the radar

Q:Leds are the ones that are brightest

The full plastic tube (aluminum) > glass tube > half plastic half aluminum is recommended. The glass tube is fragile and is restricted in use.

Q:Is there any LED fluorescent lamp that can be used for more than five years?

If it is lit 24 hours a day, leds will not work. The lamp tube is the built-in power seal belt, the heat is not good the life span is long. But it can be custom-made, use the anti-sulphur lamp bead without cover type design, heat dissipation should be done particularly well, the external constant current power supply, the current hits 50% rated current. Five years is no problem.

Q:If the led lamp is replaced, the lamp power should be small

B: yes, half of it. 20w is much brighter than before.Yeah, how else to say energy efficiency.I hope my answer will work for you.

Q:The LED light bulb is more efficient than the daylight lamp

Can protect your eyes and qualified products in China, the basic of any a light to the eyes hurt, LED lamp and light emitting diode lamp, the state encourages production vigorously, buy lamp open have a closer look at the light shake when light feeling, not a naked eye looks slightly flashing, don't feel it is good to flash to the naked eye

Q:Why is the household daylight lamp attached to the battery?

No, there aren't more than 40 fluorescent lights. Anything else.How big is the tube and the battery? There is nothing else.

Q:Now the home decorates is to use LED good or the good of the lamp tube

Now the home is decorated with LED. LED lamp tube also commonly known as the light tube, daylight lamp tube, its illuminant USES LED as the light body. The traditional fluorescent tube, also known as fluorescent lamp, lamp on both ends of each have a filament, inside the tubes filled with tiny amounts of argon and the thin mercury vapor, tubes coated with phosphor, on the wall between the two filament gas when conducting an ultraviolet, the phosphor emit visible light. Led bulbs have many advantages, such as general lighting, office buildings, shopping malls, restaurants, schools, homes, factories, etc. The lamp tube is a kind of fluorescent lamp (or fluorescent lamp, light tube, fluorescent tube), the diameter is 5/8 inches, about 16mm, belongs to the gas discharge lamp. It USES electricity to activate mercury vapor in argon or neon gas, forming plasma and emitting short wavelengths of ultraviolet light, causing the phosphor to emit visible fluorescence to illuminate. The normal fluorescent tube is made of glass, with a socket at both ends to connect the power source and the fixed fluorescent tube. The fluorescent lamp tube is a gas discharge luminescent light source, according to the pipe size of T12, T10, T8, T6, T5, T4, T3, etc., the current T8, T6, T5 are mainstream. Especially since the T5 fluorescent lamp tube, the technical performance is advanced, the light effect is high, the lighting quality and the effect is excellent and so on the technical characteristic, is replacing the T8 fluorescent lamp tube with the faster speed.