T12 Led Tube Replacement

Hot Products

FAQ

Why don't leds need a rectifier
LED is a dc device, and the driver must be different. If you do not remove the rectifier, you may not install the LED lamp.
How many leds will be able to reach the 30W T8 lamp?
The fluorescent lamp is usually 45LM/W but half of the light is an invalid LED flashlight which is about 85LM/W.
How is the T8LED fluorescent lamp installed?
If it is old fashioned, you must cut the input of the ballast and install it as shown below.
What is the connection of the LEDT5 lamp tube, the main line is how to connect, only to the end
You look at the instruction manual, this kind of lamp does not lead to ground line, see if can adjust brightness? Or the color palette? But such a small lamp is almost impossible to implement, or the yellow line is simply suspended, and the usual ground line is the outer shell of a metal shell
How does the traditional daylight lamp tube replace the LED light tube?
The regenerator will be removed with the rectifier.I hope my answer is useful to you.
Are LED lights like regular daylight bulbs
LED, long life, no flash, and low voltage current, energy saving, luminous efficiency. That's all I can say.
Is the normal daylight tube replaced by an LED line
Step 1: use a screwdriver and a pliers to disconnect the ballast from the wire. But my home is the sun lamp base of zhengtai, the quality is too good, it took 10 years. I didn't even get down to the ballast, which was stuck in a full thick iron base, so I disconnected the wire. The wire that disconnects from the ballast is sure to have two heads, just to disconnect the connection. There is a lot of direct skewers of black tape, some of which use that connector and screw the two wires together. It's the same thing. This is the connector that is used in this case. Disconnect the regenerator, remove the wire and then rewire the two broken wires together and attach the black tape (which is the insulating tape). Put the base back to the original. Install the fluorescent tube, and remember to place the head of the European logo on the base of the current. And when you put it in place, it's going to be OK.
How to remove fluorescent lamp tube
Turn off the daylight power supply; Two, the old daylight lamp two have a gap at the end of the rotation 90 degree, the double needle pulls out from the gap, the other end pulls out. Three, the old electronic rectifier without gap, is elastic, right hand hold to the right of the plastic head, left hand hold tube push 1 centimeter or so, to the right lamp tube needle left out at this moment, at the same time left hand move down the left tube face, left hand to pull in front of the tube to the left. If it is an LED tube aluminum alloy, you want to remove the contents of the inner tube, both of which have two cross screws, and the screwdriver can be removed. The leds that do not understand the electrons should not be removed. Five, the LED lamp that still has glass in the market at present, this kind of is one-time, two is to use the bad of glue stick to be thrown away, have no maintenance value. Don't take it down and you may hurt your hand.