Q:The characteristics of hydraulic platform

Light weight, good maneuverability, suitable for individual operation. The special mast strap-step device, which is smoothly and smoothly; 3, compact structure, small size of transportation, can enter the car of general elevator and pass through the door and narrow passageway. Double protected leg structure, work safer, and can be close to the working face lift.

Q:What is the imported hydraulic platform car? Kneel and beg your help

Their platform has a special mechanical structure that is widely used in high-altitude work, the shear fork structure, and the higher stability after lifting and lifting

Q:Is the elevator moving faster or slower?

The speed is relative, but the best speed is not over half m/s.I hope my answer will help you.

Q:The characteristic of shear fork platform

Electrical control mode; Work platform form; Dynamic form; Walking actuators and so on. The correct choice of all kinds of configuration, the function of the lifting platform can be maximized, the best use effect is obtained.

Q:Tomb raider 9 research base elevator to go to go to go to go to the order to pry the gear not to go down to go down to go down the card 3 to break up

When I play this card for a long time, also I am getting rid of the four is only the past, the front three gear easy to find, the fourth in 3, 4 layer between the right of the lift, there is a hole, was blocked by a few boards, you can go out from there the fourth also make it

Q:What is the main shaft of the horizontal milling machine

Horizontal movements of spindle of the milling machine is driven by servo motor, each after a pair of tooth belt pulley deceleration, to the longitudinal, transverse and vertical feed movement of the ball screw to achieve three direction.

Q:The automatic mahjong machine has a lift station always one. What is the other three normal

There are two main reasons for this: In the ascent of the aluminum plate, the interference with the limit mechanism

Q:How do you remove the horizontal universal elevator milling cutter

When the milling cutter is removed from the vertical milling machine, the lever nut must be released and then the end of the rod is gently tapped. ; You should not release too much, as long as you have some loose space. When you release too much, the thread connecting the rod and the milling cutter is too short, and when you tap, you slip and even drop the knife.

Q:The purpose of the rail elevator

Guide lifter is a kind of hydraulic elevating shear machinery and equipment. Used for secondary and tertiary industrial workshop, restaurant, wine shop floor between the transport of goods. The minimum height from 150-150 mm, optimal it is suitable for the workplace can't excavation pit. And do not need the upper lifting point, in the form of diversification (single column and double column, the four pillars). Equipment running smoothly, guide of elevator guide rail is commonly channel steel, H steel, square tube welding, operation is simple, reliable and convenient transport of goods economy.

Q:How do you jump to the wall and jump to the wall?

Hello, this is A question that I have also encountered, not by these three keys, but by right and A, and then by space. Hope to help you.