Q:What is the B axis of the NC table of the horizontal machining center and what is the mode of movement?

First, any machining center has three basic axes, X, Y, and Z. By right hand rule, you can determine the respective directions of the three shafts. As for A, B, the C axis is the three axis rotating in X, Y, and Z directions, you see!

Q:What is the workbench?

Working table is a broad concept, the pipeline may also be called a work table, the operation panel can also call the factory maintenance work table, a table is called the table, and the clean bench, double work table, single table, and according to the material is not the same name, 201 table, table 304 etc.! Because the problem is too wide, temporarily said so Dora

Q:Longmen milling machine table can only move in one direction, what is the reason?

Failure of reversing valve

Q:I want to install the cylinder on the rotary table. I want to use pneumatic rotary joint to solve the problem of trachea winding. Can you tell me if the rotary joint is connected to the cylinder or what?

It's so complicated. Generally, the joints can be rotated at a certain angle, but if you turn the circle, the pipe may be twistedYou don't seem to be able to solve the problem of trachea entanglement with this method.. If you have any doubts, you can consult E.MC's Pneumatic technologist directly

Q:Today in the car sprinkled some toilet water accidentally spilled the table aboveNow get a piece of white cloth is out to doPlease give me a support, thank you!

Liquor, alcohol wipe ~! Or the family dedicated to wipe the leather can be used with Cabernet Franc

Q:To answer why the Excelle table is split into it nabuxialai

Get down, look, there's a screw in it

Q:How can the anti-static worktable be earthed?

According to specifications, wires shall be attached to conductive metal posts that are directly hit on the soil.

Q:The working principle of the machine table of the left and right!!! Please, urgently.

Working principle of machine tool table: it is mainly used in the plane of machine tool working. There are holes and T groove on it. It is used to fix the workpiece and clean the iron filings produced during the process. Manufactured according to JB/T7974-99 standard, the products are made of ribs, plates and boxes. The working face is scraped and scraped, and V, T, U and round holes and long holes can be machined on the working face.Features of machine tool table: moisture resistance, corrosion resistance, non fading, low temperature coefficient and so onMaterial requirementsMachine tool table material: after two manual processing (artificial annealing 600 degrees -700 degrees and natural aging 2-3 years), the use of the product precision stability, good wear resistance.Specification parameterMachine size: 300mm * 300mm 3000mm * 6000mm (according to the machine table a variety of customized user requirements) machine precision: according to the implementation of the national standard verification procedures, respectively 0, 1, 2, 3 and four grades.

Q:Who knows how to connect the NC rotary table to the CNC system? Is the main control signal line sensor and a pneumatic valve power supply line (I use the pneumatic clamping), can provide the copy of the relevant instructions?

Don't you have an electrical wiring diagram? No machine is different

Q:What is the kn table

Sellers are cattle, Taobao, morning glory.