Q:Bed electrical control technology, as shown in the diagram, ask: if the work station to run at both ends, want to stay for 10 seconds, how to control the design of the circuit?

A time relay in his one normally open contact to coil KM1, KM2 series electric locking loop, that is to say the motion of the platform to end, after the pressure switch, give him a ten seconds delay to contactor inversion of control power, so that we can realize that work Taiwan stop 10 seconds, ten seconds to remember to pay attention to the time relay is reset, the coil circuit loss of electricity, or directly to the other end of the reverse.

Q:Leze three coordinate table adjustment when the air bearing vibration to solve

1, the air source is not clean2, the platform has dust3, the pressure value is less than 0.2Mpa4, air bearing bearing scratches or blowhole obstruction5, ball screw failure

Q:What is the advantage of hydraulic automatic transmission of grinding machine table?

You should consider this horizontal hydraulic transmission and power transmission, vertical movement speed is adjustable, this premise is that you must use stepper or servo motor or pneumatic drive mode, compared with the hydraulic transmission, pneumatic transmission stability is relatively poor, and the motor drive mode and the maintenance cost the mechanical structure of production costs are relatively much higher, so the workbench of the grinding machine using hydraulic drive is the best choice in the economy and the mechanical design.

Q:I want to install the cylinder on the rotary table. I want to use pneumatic rotary joint to solve the problem of trachea winding. Can you tell me if the rotary joint is connected to the cylinder or what?

Not connected to the cylinder. It is attached to the rotating part

Q:To answer why the Excelle table is split into it nabuxialai

Get down, look, there's a screw in it

Q:How can the anti-static worktable be earthed?

Tuo professional provides electrostatic protection solutions, according to the actual needs of production, in line with Lean thought, for your personal custom

Q:What is the difference in function between the indexing table and the turret of NC machine tools?

Are you light industrial?

Q:Two are all right, check the information, and now the rotary table has two benchmark surface, vertical and horizontal dual-use, coupled with servo motor drive, indexing is also no problem.

No, the indexing head is a rotating shaft parallel to the horizontal plane of the work tableThe rotary table is usually vertical to the horizontal surface, and it does not necessarily have an indexing device

Q:In the hotel, a table called the cooker, the cooker is what to do with it?

Cooker. Just take the plate. To serve the fried dishes. To help master handyman. In fact, they are right

Q:Who knows how to connect the NC rotary table to the CNC system? Is the main control signal line sensor and a pneumatic valve power supply line (I use the pneumatic clamping), can provide the copy of the relevant instructions?

Don't you have an electrical wiring diagram? No machine is different