Q:Bed electrical control technology, as shown in the diagram, ask: if the work station to run at both ends, want to stay for 10 seconds, how to control the design of the circuit?

A time relay in his one normally open contact to coil KM1, KM2 series electric locking loop, that is to say the motion of the platform to end, after the pressure switch, give him a ten seconds delay to contactor inversion of control power, so that we can realize that work Taiwan stop 10 seconds, ten seconds to remember to pay attention to the time relay is reset, the coil circuit loss of electricity, or directly to the other end of the reverse.

Q:I used the Z axis is on the workpiece surface, and to the factory processing center, why always on the workbench, I do not understand, please master detailed instructions on its tool steps and intentions, high marks ~ ~ ~!

A simple table is facing good benchmark of different workpieces can not repeat tool there is a workpiece down to several knife so that you can have it to good use on the line when there is no other requirements

Q:How do I build a workbench in my world?

Press e put up, a wood has 4 boards, each grid put a table, workbench, left key put the articles according to the book put, new look and number

Q:My world computer how to do the workbench?

Play trees, make a thing, fill 4 squares

Q:What is the advantage of hydraulic automatic transmission of grinding machine table?

Its advantage is compared with the mechanical drive system:1. small vibration.2. stepless speed change can be achieved.3., smooth movement, low noise.Working principle: the composition and working principle of the hydraulic transmission system of the simple grinding machine. The motor drives the hydraulic pump to absorb oil from the tank, and the hydraulic pump converts the mechanical energy of the motor to the pressure energy of the liquid. Hydraulic medium through the pipeline through the throttle valve and reversing valve into the hydraulic cylinder left chamber, to promote the piston to move the table to the right, the hydraulic cylinder to the right cavity of the hydraulic medium discharged by reversing valve flow back to the tank. After reversing the valve, the hydraulic medium enters the right chamber of the hydraulic cylinder, so that the piston moves left and pushes the worktable to move backwards. Changing the opening of the throttle valve can adjust the speed of the hydraulic cylinder. The pressure of the hydraulic system can be adjusted by overflow valve. In drawing the hydraulic system diagram, for the sake of simplification, the prescribed symbols are used to represent the hydraulic components, which are called functional symbols.

Q:What is the height of the press table from the ground?

About 80 centimeters, of course, because the mold closed height reasons, you may need to remove the workbench table, so it is less than 80 centimeters.

Q:How do you install the fixtures on the milling machine table?

Just press the T bolt and the platen. The general milling machine uses M14 bolts

Q:What is the difference in function between the indexing table and the turret of NC machine tools?

The difference between indexing table and the rotary table CNC machine tool is that it according to the processing requirements of the workpiece rotate to the required angle, has reached the purpose of processing different surface, it cannot achieve circular feed movement, so the structure of two different

Q:The working principle of the machine table of the left and right!!! Please, urgently.

Your question is not very clear. What do you mean by the worktable of the machine tool? Plain Miller or flat mill? Or the machining center?The general principle is the same. The movement direction of the worktable is controlled by the limit or reversing device of the worktable and the reversing switch. Is to use the weak current to control the strong electricity. Only numerical control is done by means of feedback. All motors (service motors or AC and DC motors) are passed to the lead screw (ordinary lead screw or ball screw) to complete the movement of the table.

Q:Who knows how to connect the NC rotary table to the CNC system? Is the main control signal line sensor and a pneumatic valve power supply line (I use the pneumatic clamping), can provide the copy of the relevant instructions?

Don't you have an electrical wiring diagram? No machine is different