Electric Forklift Truck (1.0-1.5ton)
Load Capacity:1T - 5T
General Manufacturer GP
1. Model: CPD10, CPD15
2. Rated capacity kg: 1000, 1500
3. Load center mm: 500
4. Power type: Battery
5. Tire type Front/Rear: Pneumatic
6. Wheels Front/Rear: 2*2 Dimensions
7. Lift height mm: 3000
8. Free lift height mm: 162.
|8||Free lift height||mm||162|
|10||Mast tilt angle||Fwd/Bwd||deg||6/12|
|11||Overall length (without fork)||mm||2056|
|13||Mast height fork lowered||mm||1995|
|14||Overall height fork raised||mm||4042|
|15||Overall height (overhead guard)||mm||2162|
|16||Turning radius (outside)||mm||1820|
|17||Load distance (centerline of front axle to front face of forks)||mm||429|
|18||Minimum Aisle -90 degree stack(Add load length and clearance)||mm||3370|
|22||Min. Under-clearance ||Bottom of mast||mm||95/110|
|23||Bottom of frame||mm||95/105|
|Performance||24||Speed||Travel Max.||With load||km/h||11.5||11|
|28||Max. Drawbar pull||With/without load||Kn||6||6.5|
|29||Max. Gradeability||With/without load||% (fan)||15|
|power control||33||Battery||Voltage ||V||48|
|35||Electric motor||drive motor||kw/rpm||5.3/1700|
|37||controller||GE separate excitation controller|
- Q:The basics of driving a forklift
- Adjust the distance of the cargo fork according to the volume and shape of the goods, and make the right and left fork force even. When taking the cargo or pallet, the fork should be inserted at the insertion hole level of the pallet, avoiding the collision as much as possible, and then the fork of the cargo after the cross, and then the door frame. Before you start, look around the forklift and the cargo stacking and keep the fork from 20 to 30 centimetres above the ground to prevent the cargo from falling. The whistle should be sounded when entering or turning.
- Q:The forklift license test is for those
- Security, the structure of the car, the books. The main thing is,I hope my answer will help you
- Q:What about the exhaust fumes of the internal combustion fork in the workshop
- A forklift exhaust gas purifier. Shanghai jiekai supplies imported forklift exhaust gas purifiers, which is 90 percent efficient.
- Q:What are some of the common failures of forklifts?
- Forklifts cannot be started with the following conditions: 1, the battery without electricity Failure of starter The key switch is bad 4, the oil pump does not supply oil 5, there was no oil tank 6, no oil 7, the crankshaft lock The engine was completely scrapped
- Q:What insurance does a forklift driver need?
- Forklift truck drivers in the company, in addition to social security required by the company, also can buy a accident insurance for employees, such risk, one thousand for the company's pressure is small.
- Q:Whether there is a national standard or standard for the charging of forklift truck in the factory
- The charger must be equipped with two fire extinguishers. 6 above, battery and battery must be kept clean, dry, no residue cover need and can't damage the battery connection in place, the battery with the charging cable can't kink and damage, insulation parts can't be..
- Q:What is the difference between a forklift mechanical drive and a hydraulic drive?
- Hydraulic drive has a smooth, smooth and easy control. When the gas pedal is released, the shutdown of the oil circuit also causes the vehicle to slow down automatically. I won't tell you what the maintenance costs are, but the hydraulic car is expensive and the parts are too expensive and the parts are too expensive. But as long as normal use and maintenance is ok. Using hydraulic drive advice, use linde.
- Q:Notice those items before the forklift
- Forklift yearly check just need certification, then the body on the nameplate on, can clearly see that the above information such as the factory number, if not the first time a yearly check, just the last annual inspection report, but your forklift every performance must be in good condition.
- Q:There are several possibilities for a forklift battery bomb
- There are several reasons for the battery explosion, first of all, the battery is caused by a normal internal short-circuit.
- Q:What's the difference between a forklift?
- There are two types of forklift certificates: operation and classification 1, operation certificate is engaged in the work of the proof, in pledges inspect bureau to deal with, special operations personnel must accept adapted to this type of work, special security technology training, tested and approved by the safety technical theory and practical operation skills examination qualified and obtain special operations after the operation, can mount guard operation; No training, or training appraisal, may not be done.
1. Manufacturer Overview
|Annual Output Value
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
|No. of Production Lines
|Product Price Range