Q:Can diamond saw blades cut concrete?

Because the hardness of each place is not the same, or there are steel, pebbles, and other high hardness material, the required blade grade are not the same.

Q:What is the cutting of reinforced concrete?

Reinforced concrete cutting refers to the use of hydraulic wall sawing machine, electric dish saw machine, diamond or road cutting machine and other tools for concrete components, walls, pavement and other cutting technology

Q:What is the role of concrete in the material?

Since the emergence of Portland cement in the 1920s, the concrete used in it has the strength and durability required for engineering and is easy to obtain, low in cost, especially low in energy consumption,

Q:Can concrete be cut into tiles?

and after water mill, pickling, waxing, polishing. Generally available for floor or other finishes.

Q:What should be noticed when cement concrete pavement is cut?

3, the spacing should be appropriate, the general control between 4-6 meters, the interval is too long, there will be cracks in the middle, from the role, too short, but also a waste;

Q:Why the cement concrete surface cutting block should be avoided less than 90 degrees

According to the day pouring temperature, such as 35 ℃, can be cut off within 10h-12h.

Q:Concrete condensation hardening process, cement hydration to release a lot of heat, resulting in concrete temperature rise; most of the cement hydration reaction is over, the concrete temperature began to decline.

Then, the road shrinkage to fill the asphalt or sealant to seal, to prevent rain water into the roadbed.

Q:What are the characteristics of concrete saws?

Concrete cutting is the use of water-cooled diamond track or rope saw cutting machine on the concrete hole, demolition

Q:What to cut aerated concrete blocks

cross cutting mechanism, horizontal cutting car, hydraulic system and electric control system

Q:What is the difference between crosscutting and slitting of aerated concrete cutting machines?

Hexahedral cutting, refers to the level of cutting and vertical cutting,