Q:How does the T8LED light tube replace the fluorescent lamp tube

Step 1: use a screwdriver and a pliers to disconnect the ballast from the wire. But my home is the sun lamp base of zhengtai, the quality is too good, it took 10 years. I didn't even get down to the ballast, which was stuck in a full thick iron base, so I disconnected the wire. The wire that disconnects from the ballast is sure to have two heads, just to disconnect the connection. There is a lot of direct skewers of black tape, some of which use that connector and screw the two wires together. It's the same thing. This is the connector that is used in this case. Disconnect the regenerator, remove the wire and then rewire the two broken wires together and attach the black tape (which is the insulating tape). Put the base back to the original. Install the fluorescent tube, and remember to place the head of the European logo on the base of the current. And when you put it in place, it's going to be OK.

Q:LED T5 T8 and normal fluorescent lamps with no ballast

Say something practical, high brightness LED, energy saving, but there is light, if you are not willing to spend money to buy things, light failure will be very serious, fixtures are usually carry an umbrella the double tube is 20-30 yuan, tubes T5led18W market price has 40 - XXX, basically see the quality stand or fall, philips lamp wholesale is 5 yuan, fluorescent lamp with ballast, points electronic with inductance, the inductance of the durable, but noisy, electronic not durable but little noise, hand to hope to adopt

Q:A 30-watt light bulb can be used for a change of LED lamp

The fluorescent lamp bracket some trouble, generally in the power of the led lamp is generally in 18 w 9 w, 600, 36 w in 18 w, 1200 long, 30 w words should be in 12 or 15 w, do you want to make sure the tube length.

Q:How does the lamp line connect

If the lamp is ordinary lamp, that is the kind of tubes, tube wall coated with phosphor is need ballast, if it is a led lamp, does not need ballast, later I'll detail

Q:Excuse me, the lamp in the sitting room lamp is carried good or the lamp tube is good

The lamp slot can choose LED lamp belt! The power is small, the light effect is very good too! Do you need any other lights? Our factory is specialized in the production of modern contracted lighting lamps and lanterns!

Q:I have LED lights on the fluorescent lamp, and I tested it when I was running five times a dc, and four LED lights were very bright and hot,

But I'm very weak with five of these five, and I'm supposed to say that one 1.25 volts, 176 times and 1.25 is 220 volts,

Q:The difference between the Ledt5 lamp and the temperature 3000k and 2700k

The color temperature of 300K is not very different, with the naked eye, it is very difficult to distinguish, using the instrument test · · the color temperature is high, the color is white, the color temperature is low the red, 6000-6500K is the positive white

Q:What are the types of leds?

The T5 is powered by a small lamp and no power supply. The component is the power supply of LED lamp tube, buy return is a light tube + a set of power supply, the installation time should use the old lamp tube support, also install the power supply

Q:Electronic ballast tube lamp change led lamp tube how to change circuit how to do

It is not a direct replacement, it is a light source that is different from each other, and the driver is different. It is necessary to use the (complete replacement). Fluorescent lamp tube + ballast = former fluorescent lamp. LED lamp tube + drive (constant current or stabilized power supply) = new LED lamp. It is not only the size of the wattage, but also the variety of the lamp, which has high voltage, voltage and middle voltage, and the actuator must be used with the lamp. Leds must be aware of the following points when removing the installation: Leds should not be under too much pressure. The installation should be installed by an electrician or the person familiar with the circuit, to avoid the danger of electric shock. Please contact with the purchase manufacturer in time for any distortion or damage

Q:The life of LED fluorescent lamp tube

LED fluorescent lamp power saving more than 80%, life expectancy of more than 10 times of ordinary lamp, is almost free maintenance, often there is no want to change the lamp, ballast, the problem of electric fluorescent starter, about half a year down can switch back to the cost of cost savings