Q:How to adjust handwheel mode in NC lathe

LOW, MPG*1, MPG*10, MPG*100, that is, 25%50%100%

Q:A problem with PROE rookie drawing hand wheel, please people generous with your criticism

Variable section scan or mixed scan. Then the array.

Q:What is the handwheel of the valve?

A driving device that controls the opening or closing of a valve. A manually operated handle or handwheel is provided to control the valve switch

Q:Machining center Z axis can not move, switch machine also useless, hand wheel did not move, but the number of strokes on the screen is still moving

Shutdown or emergency stop, turn on the Z axle shield, turn the Z screw with hand. As long as it is not a large machine tool or a parallel shaft, you can turn it, turn it several times and turn off the limit switch. Hope to be of help to you

Q:How to use the reverse switch HaiGan handwheel below

The reverse switch is reversed, and clockwise rotation after opening.

Q:Wide number of 980TD system, according to the "hand wheel", the screen shows the right hand side of the "hand wheel", but "relative position" does not jump, is not the system broken?

There is a problem with the parameter. The parameter has not been selected. Use the hand wheel, the serial number 001, to see the five digit. Is it 1?

Q:Lifting dumbbells is 2 hands at the same time lifting, or two hand wheel is good? Is there any difference?

Taking turns is not easy to hurt, and can insist on more, so that it is easier to practice, and at the same time to increase coordination, but not enough rest, less done, but also tired

Q:CNC machine tools, hand and hand wheel are not good, what's the matter?

CNC machine tools manual and hand wheel are not easy to use, usually caused by oil dust, it is recommended to remove after cleaning with detergent or industrial alcohol, you can. If it is caused by severe mechanical wear, it is only possible to replace it with new ones.

Q:What is the principle of the mechanism that the hand wheel adjust the upper and lower clearance of the hydraulic brake shears?

This structure is OUT, and now are electrically adjusted, mainly by adjusting the front and back distance of the upper tool holder

Q:I think it's probably the back line. I'm not sure if the line is the handwheel. Who can tell?Now the handwheel does not respondAlso, my unit now has a CNC display on the SHIFT should be played after the letters, characters are all wrongCan anyone explain that, please?

1, the handwheel signal can through the address diagnosis, different IO card address is different, such as special 0I IO module, X13 address is the address signal wheel, hand wheel, the address value will change, if not change, can check on the handwheel 5V voltage is in place, the hand wheel is directly connected to the IO module, interface JA32, the problem is not very clear, according to the SHIFT, the input will certainly be differentIf that doesn't mean, then empty the parameters and try again. This requires debugging knowledge of FANUC