wooden cases is suitable for long distance exporting.
30-45 days after receiving L/C or payment in advance
PS Board Base
Send a message to us:
Q:is there aluminum oxide on the surface of aluminum sheet after being polished by abrasive paper?
aluminum will be oxided as aluminum oxide once being exposed in air.
Q:how to process 0.3mm hole on aluminum material?
punching wire-electrode cutting
Q:why does the bubble apear a few minutes later after putting aluminum sheet into dilute sulphuric acid?
it firstly etches off the oxide on the surface of aluminum, and then reacts with aluminum, generating bubble.
Q:how to avoid oxidation of aluminum sheet after wire drawing?
leave it alone after wire drawing!aluminum sheet will formulate a layer of dense oxide film. So you don't need to worry about it! Don't often polish the aluminum wire, or they will be more and more slimsy, the oxide film is used for avoiding reoxidation.
Q:does aluminum sheet has a function of magnetism isolating?
copper sheet is better.
Q:who knows the ceiling technology of aluminum sheet?
Construction technology of ceiling aluminum sheet: (1) firstly check keel’s quality, the straight shape and uniformly forced state of boom, control the keel’s gap within 500mm, reduce the gap according to design requirement under humid environment. The lower surface of keel is smooth without a sense of bearing down, main device is closely connected with accessories, it can be bound after being confirmed qualified.(2) we should break the board along the cutting line and ensure the margin of cutting board straight and square without any chipping or arris defect. (3) while placing and fixing the board, we can place edge of aluminum-plastic panel(encapsulated edge) in the vertical direction of supporting keel, there is a phenomena of hanging. Aluminum-plastic panel should be placed closely in the process of butt joint, it can’t be pressed. You can start from a plate angle or middle position, and don’t place them at the same time. Slab joint should be straight and in the same width, without break joint. (4) in the process of joint, Aluminum-plastic panel should be placed closely in the process of butt joint, it can’t be pressed. And the butt joint should be stagger, the butt joint can’t be connected on the same keel. When you use doubling plate, the joints of the second layer board and the first layer board can’t be connected with the same keel, double-deck gypsum board should be staggered joints.
Q:after putting aluminum sheet into the area between magnet and iron products, could magnet attract iron again?
magnet can attract iron if the aluminum sheet isn't too thick. Because aluminum can't cut off magnetic line of force, unless aluminum sheet's thickness surpass the range of magnetic attraction.
Q:is aluminum foil spacer poisonous after heating?
many baked food will use aluminum foil.
Q:could aluminum sheet be attracted by magnet?
no, it couldn't.
Q:how to find 0.6mm waste strake of aluminum sheet?
Heating wire is mainly used for electrical heating, has large power consumption. But aluminum sheet’s cooling fin mainly uses steam or hot water to conduct Thermal dissipation, it needs hot water or steam boiler. Comparatively, Heating wire conducts Thermal dissipation quicker, but cools quicker after power outage. Aluminum sheet is in the opposite condition.