Ceiling Light Fixture Cover Plate

Hot Products

FAQ

Bedroom suction top LED color change lamp, how to install to change color?
if the switch is controlled, that is, through the switch of the continuous switch to control different color change, my family is like this, then you need to put the lights installed
The ceiling light is still flashing after closing
Because of the zero line is disconnected, did not form a loop, energy-saving lamp ballast must be installed to shine, FireWire on the ballast is not completely off, the capacitor will charge and discharge of ballast in time, every few seconds flash.
Installation method of rectangular ceiling lamp How can I fit the lamp in the middle of the roof?
The first thing to do is to determine the installation position of the ceiling lamp.
How can the square ceiling lamp be taken out?
With a suction cup (sucker type hook) attached to any corner of the light, gently down, you will take the light down.
How about crystal ceiling lamp? How to choose crystal ceiling lamp?
the choice of crystal, not only easy to be water vapor interference light, and is not easy to clean, clean, fresh flowers is the wrong place.
A flash of overhead light
if the switch control is FireWire, turn off the switch after flicker, prove the lamp itself problems (electronic ballast without discharge device, which is the lighting industry in the electrolysis without discharge resistor
Bedroom ceiling light 18W and 24W difference, the trouble explained in detail, easier to understand
Warm white and white are what you like. Warm white is good for winter. The light from a warm white column is similar to the sun's rays. It looks like a warm feeling. It looks just a little bit more comfortable.
Where is the control line of the ceiling lamp and how can I get it?
First of all, to distinguish the nature of the three lines in the ceiling lamp, the three lines are: FireWire line, L line, zero line into line, N, ground protection line PE.