Q:How does the T8LED light tube replace the fluorescent lamp tube

Step 1: use a screwdriver and a pliers to disconnect the ballast from the wire. But my home is the sun lamp base of zhengtai, the quality is too good, it took 10 years. I didn't even get down to the ballast, which was stuck in a full thick iron base, so I disconnected the wire. The wire that disconnects from the ballast is sure to have two heads, just to disconnect the connection. There is a lot of direct skewers of black tape, some of which use that connector and screw the two wires together. It's the same thing. This is the connector that is used in this case. Disconnect the regenerator, remove the wire and then rewire the two broken wires together and attach the black tape (which is the insulating tape). Put the base back to the original. Install the fluorescent tube, and remember to place the head of the European logo on the base of the current. And when you put it in place, it's going to be OK.

Q:What material is LED fluorescent lamp fittings, such as shell, block?

The bottom case is pure aluminum, solving the problem of divergence; The mask is a PC milky white or transparent to solve photoelectric transmission and visual effects. The plug is made of plastic, not easily broken and safe.

Q:Do not have the fluorescent lamp of actuator, how to change LED lamp tube?

Want to change LED lamp to match, the piece of fluorescent lamp is not usable.

Q:Why don't leds need a rectifier

Because LED is a direct current is needed to light, and the output voltage of rectifier is an alternating current, so can't use rectifier, now LED lamp is built-in power inside, and use it every time you'd better put fluorescent original rectifier and demolition of the starter, but given the easy to use, now LED lamp can be directly on the original fluorescent lamp holder, do not need to disconnect the rectifier, only need to send a link of the starter circuit cut. Because the regenerator will provide an instantaneous high voltage, it will damage the LED

Q:20 square metre room application which led fluorescent lamp tube

The lamp tube can use 20w t8 1.2m LED light tube 6500k.I hope my answer is useful to you.

Q:If the body is accidentally broken, will it be electrocuted?

You don't touch the electrodes without touching the two electrodes. But be careful when you break

Q:Leds are the ones that are brightest

The full permeability of all plastic tube tubes can reach more than 90% or even 95%. And it has a large luminescent surface of half plastic.

Q:If the led lamp is replaced, the lamp power should be small

Yes, there is a difference in color temperature between 14 and 18W.Yeah, how else to say energy efficiency

Q:The two ballast that originally was electric inductance towed three ordinary fluorescent lamps, now changed to LED fluorescent lamp tube, have influence?

You slam the door of the original circuit, LED fluorescent tube is in with the drive, as long as according to the directions, the wire connected, the zero line of the original circuit is a traditional fluorescent lamp ballasts, and LED is not the same, so you can cut down, the original circuit directly connected to your leds.

Q:Are led fluorescent tubes not available for lighting?

But to see if there is a built-in power source, the external power source is not directly 220V,