Q:What are the processing defects of plywood?

Warping warPing is generally a regular deformation, part or all of the surface of the plywood is curved.

Q:Plywood is a common material for furniture?

With the veneer after the wood by the direction of the criss-cross the composition of the slab, heated or not heated under the conditions of suppression.

Q:What are the further processing of plywood?

Curved plywood cutved plywood Plywood that has been bent once or several times.

Q:For the plywood environmental advice?

According to the environmental protection level, the glue used for plywood can be divided into E0 grade, E1 glue, E2 glue (and even E2 level are not reach the unqualified glue)

Q:Plywood in the decoration works how to use

. With the veneer after the wood by the direction of the criss-cross the composition of the slab, heated or not heated under the conditions of suppression.

Q:What is the amount of construction works used for this plywood?

The second type of plywood is water resistant plywood, can be immersed in cold water and short time hot water immersion;

Q:The difference between the multilayer board and the plywood is as follows

The number of layers is generally odd, and few are even. Vertical and horizontal direction of the physical and mechanical properties of small differences

Q:Hard fiber board is also a density board

the same texture direction. Adjacent two-layer veneer grain direction should be the same. The plywood should be the same tree.

Q:What are the defects of the plywood?

dead dead knots formed by the dead branches of trees, knots surrounded by the surrounding wood together, or even only part of the length of its cross-section of the length of about 1/4 or less than 1/4 , Texture hard or soft, and sometimes fall off the formation of empty.

Q:How is the current market outlook for plywood?

Although China plywood has developed rapidly, but still encounter the EU and other importing countries of the anti-dumping complaints