Q:What is a limiter?

The compensator of the inner sleeve shall be noted that the direction of the inner sleeve is consistent with the direction of the medium flow, and the hinge rotation plane of the hinge type compensator shall be in accordance with the displacement rotation plane.

Q:How do you pull the contracted muscles with a mechanical device?

A muscular spasm is a controlled contraction that causes the muscles to be tense and rigid, usually caused by lactic acid accumulation. 1) massage the muscles. 2) gently pull the muscles. Namely: 1 spasms can occur in any muscle, usually caused by unaccustomed activity, often occurring in the calf muscles of the gastrocnemius. When you massage, the injured must sit or lie down. 2 gently pull the muscles to counteract the spasms, and pull the foot to the shin in this case. Massaging and pulling muscles can increase the flow of blood in the muscle to take away and disperse the local lactate. Muscle spasm first aid Beijing Morning Post muscle spasm is commonly known as cramping. It is an involuntary tonic contraction produced by the muscles.

Q:Is the construction of the water supply steel pipe a telescopic device?

The pipe line survey shall be carried out in accordance with the coordinates of the pipe line control points. In order to master the control points of the canal well, the permanent reference piles shall be introduced and set up in the engineering site, and properly maintained, and the project shall be submitted to the owner after completion of the project. After the above work, please check the line of supervision personnel, confirm the ditch excavation work.

Q:What are the main uses of a bolt tensioner?

Stretch, fasten, or loosen the bolts and think of the bolts as a rubber band,

Q:The working principle of the bolt tensioner

During operation, the high-pressure oil output by the power source is conveyed to the piston cylinder 3 by a high-pressure hose, and the piston in the piston cylinder moves upward under the action of pressure to drive the stretching nut upwards. The nut and bolt tensile work thread, thereby stretching the working bolt, the bolt elongation reached the required amount of deformation, deformation control in the elastic deformation range, then the pre tightening or disassembling operation, finally through the hydraulic or mechanical return the work bolt return to its original shape, finish the homework.

Q:What kind of materials are used in the telescopic equipment of machinery industry?

The most common form of bond failure is shear. So the key requires enough strength and steel. No. 45 is the most commonly used steel.

Q:How to achieve telescopic power arm

It is better to use a hydraulic lever, which is simple and can be fitted with a fixed device to control his travel distance,

Q:Mechanical structure and principle of automatic focusing lens for camera

From the basic principle, AF can be divided into two categories: one is based on the camera and photographed location AF target distance between measurement and another is based on the focus screen clear focus imaging detection.

Q:Mechanical principle of belt expansion machine

Principle: the telescopic belt conveyor adds a telescopic mechanism to the ordinary belt conveyor, so that the belt conveyor can be freely extended in the length direction.

Q:What is the automatic telescopic function of an automatic umbrella?

Working process and principle analysisA. the long handled umbrella is in a tight position, that is, the middle slide is at the lower dead point1. the elasticity of the spring 1 at the moment reaches its minimum value and is greater than 0.The 2. middle slider is at the lower dead center and is locked by the bump switch 1.On the 3 of the 3. rib buckle at the fulcrum of the slider 2, a spring 2 stretch for 0.The B. long handle umbrella is at the beginning of the opening, i.e., the middle slider begins to move up