Q:What is a limiter?

To understand what a limiter is, you should first know what a telescoping device is The expansion device is also called expansion joint, expansion joint, compensator and expansion joint. Expansion device capable of axial expansion in a certain range, the offset can overcome different axial pipe butt within a certain angle and produce, installation and convenient disassembly pipeline valve greatly, in the pipeline to allow expansion in free expansion, once over its largest expansion amount rise to limit, to ensure the safe operation of pipeline the

Q:What are the main uses of a bolt tensioner?

Stretch, fasten, or loosen the bolt and think of the bolt as a rubber band. It is flexible and can be stretched freely within its range of elastic deformation

Q:Is the construction of the water supply steel pipe a telescopic device?

The pipe line survey shall be carried out in accordance with the coordinates of the pipe line control points. In order to master the control points of the canal well, the permanent reference piles shall be introduced and set up in the engineering site, and properly maintained, and the project shall be submitted to the owner after completion of the project. After the above work, please check the line of supervision personnel, confirm the ditch excavation work.

Q:What is a bolt tensioner? How do you use it?

Ensure the load is required in the standard setting, screwing length of screw thread is also provided; ensure the load refers to the mechanical test project of bolts and nuts, the threaded part is load bearing ability (because the threaded portion of the most vulnerable).

Q:The working principle of the bolt tensioner

During operation, the high-pressure oil output by the power source is conveyed to the piston cylinder 3 by a high-pressure hose, and the piston in the piston cylinder moves upward under the action of pressure to drive the stretching nut upwards. The nut and bolt tensile work thread, thereby stretching the working bolt, the bolt elongation reached the required amount of deformation, deformation control in the elastic deformation range, then the pre tightening or disassembling operation, finally through the hydraulic or mechanical return the work bolt return to its original shape, finish the homework.

Q:What kind of materials are used in the telescopic equipment of machinery industry?

The most common form of bond failure is shear. So the key requires enough strength and steel. No. 45 is the most commonly used steel.

Q:What are tensile and shrink wrapping?

Shrink wrap (shrink wrap) is the use of shrink film wrapped items (or inner package), and then the film proper heating treatment, so that the film shrink and cling to the goods (or inner package) packaging technology. Shrink film is a specially stretching and cooling treatment of polyethylene film, because the film residual tensile stress in the directional contraction, the stress is heat will be eliminated, so that the horizontal and vertical were sharp contraction, while the film thickness increases, the shrinkage rate is usually 30% to 70%. The contraction force reaches the maximum value at the cooling stage, and can keep for a long time.

Q:Mechanical structure and principle of automatic focusing lens for camera

The principle of the infrared ranging method is that the camera takes the initiative to emit infrared light as the distance measuring light source and the geometric relation between the infrared LED, and then calculates the focusing distance.

Q:Mechanical principle of belt expansion machine

Principle: the telescopic belt conveyor adds a telescopic mechanism to the ordinary belt conveyor, so that the belt conveyor can be freely extended in the length direction.

Q:What is the automatic telescopic function of an automatic umbrella?

Working process and principle analysisA. the long handled umbrella is in a tight position, that is, the middle slide is at the lower dead point1. the elasticity of the spring 1 at the moment reaches its minimum value and is greater than 0.The 2. middle slider is at the lower dead center and is locked by the bump switch 1.On the 3 of the 3. rib buckle at the fulcrum of the slider 2, a spring 2 stretch for 0.The B. long handle umbrella is at the beginning of the opening, i.e., the middle slider begins to move up