Q:What does the diameter of a car tire determine? Is it better to bend over a big diameter or a small one?

Cornering is good, do not look at the tire size, see chassis height, shock hardness, low chassis, cornering safety shock hard, has decided to turn the tire quality, flat tire safety is higher than the ordinary tire, the price more than half of Kazakhstan, tire safety brand good in general brand tires such as Michelin, Goodyear, Pirelli, the world brands, good quality in domestic brand tires. The price of expensive, intermediate quality and price is ZhengXin tires and HANKOOK tires, Bridgestone tires. Low quality and price is not introduced

Q:Does truck tire have inner tube?

There is a inner liner! TUBELESS said this tire design uses a tubeless vacuum tire, also known as ""

Q:How often do the tires change?

If there is partial wear, eating tires, should be done as early as four wheel positioning and tire transposition; standard transposition method is the same side before and after transposition. A car tire 2.5 in winter, 2.2 in summer, the highest pressure tire can withstand the tire side, reasonable pressure of tire mark maximum pressure of 70%-80%, but it is best not to pressure higher than the maximum pressure of tire mark.

Q:What happens when a truck tire is not round?

The tire is the most important component in the vehicle driving system. It is related to the driving safety. If the tire is found to be a problem, it should be repaired immediately.

Q:Where is the replacement truck or bus tire at the fleet repair shop?

The place that sells a car can have tire to sell commonly, but it is the 4S shop of car commonly. Wuhan gathers the specialized card, the passenger train tire brand monopoly, the specification is complete. At the same time, you can also search under Baidu Hubei Wuhan area agent tire company, looking for an agent, then the price can be cheaper.

Q:What are the common problems that automobile tires need to pay attention to?

Some owners believe that when the temperature is higher, the tire pressure should be slightly below the standard value, the reason is that this can avoid the expansion of air heating caused by excessive pressure, tires, reduce the risk of tire burst. In fact, almost all tire providers do not advocate car owners to do so. Because the tire pressure drop, the tire and ground contact area increases, will cause the tire heating up too fast, but easy to cause a flat tire. In addition, the tire pressure is too low, there are many negative effects, such as: causing abnormal wear on both sides of the tread, increasing the deformation side of the tire side, easy to damage the tire side and so on.

Q:What is the difference between the thickening of automobile tires and the model of ordinary automobile tires?

Third: low fuel consumption = money - vacuum tires in the metric unit 315/80R22.5295/80R22.5275/70R22.5 flat tire, tire crown angle is zero, so adhesion is strong. The utility model can keep good driving stability and little friction, and is beneficial to shock absorption and speed increase. The belt speed layer has high positioning, small radial runout of the wheel and small resistance. Thus reducing fuel 3%.

Q:Can the car tyres change from side to side?

The size is different, the left and right change meaning is not big, can only follow the new tire.

Q:Can truck tires intermodulation on the left and right? Because eat fetal to eat badly

Reversing the tires around is also a way to extend the service life of the tires

Q:How much gas does the truck tire?

The truck is currently equipped with a high-pressure tire.The air pressure is 0.5 ~ 0.7MPa (5~7kg/cm -), high pressure tyre for large cargo / passenger cars, the air pressure is about 0.5MPa, steel wire tire can be properly increased to about 0.6MPa.