Q:The forklift license test is for those

Security, the structure of the car, the books. The main thing is,I hope my answer will help you

Q:What is the difference between a forklift mechanical drive and a hydraulic drive?

Hydraulic drive has a smooth, smooth and easy control. When the gas pedal is released, the shutdown of the oil circuit also causes the vehicle to slow down automatically. I won't tell you what the maintenance costs are, but the hydraulic car is expensive and the parts are too expensive and the parts are too expensive. But as long as normal use and maintenance is ok. Using hydraulic drive advice, use linde.

Q:After the forklift is killed, it will stall!

Any mechanical direction killing will cause damage to the direction system! You're holding the engine out!

Q:What should 80V force forklift voltage current be?

Side forklift Powered by diesel engine, the carrying capacity is 3.0-6.0 tons. In the case of not turning, the ability to take the goods directly from the side and fork, therefore, the main purpose is to take the long line of goods such as wood bar, steel bar and so on.

Q:Is the forklift card issued by the labor bureau or the bureau of quality supervision? Which good?

There is no such thing as a license to drive, and a lot of years of technical proficiency can be used to get a lot of credit.

Q:4 tons of cross-country forklift lifts the four-meter cross-country forklift

Electric cylinder forklift: suitable for indoor or environmental protection Advantages: low noise, no exhaust emissions, easy operation. Disadvantages: high maintenance requirements, poor continuous working ability, high cost of high cost of materials. Choose different forms of forklift in accordance with your site

Q:Does the forklift have only one wheel? Front engine

Not all cars have a bad lock on them, and only high-end SUV tops! And the difference is the difference. Your mitsubishi suv is the middle bridge differential lock and the other four locks! The chances of your forklift lock are almost ze

Q:How do you tell if a forklift is retrofitted?

The simplest method, listen, listen to the sound of the engine to have the noise or heterophony, look at the engine to smoke the smoke, the door frame bearing has no wear and tear. Look up from beneath the car, such as no sludge in the sag, paint thinner, door frame without wear and walk it sounds small, small gap control system, the basic is new. Certificate of conformity, the invoice may be.

Q:What type of rubber forklift tyre

A tyre is a circular, circular elastic rubber product that is rolled on a variety of vehicles or mechanically. It is usually placed on a metal rim, which can support the body, cushion the impact of the outside, realize the contact between the road and ensure the vehicle's performance. The tyre is usually made up of the outer tire, the inner tube and the mat. According to the classification of the structure of fetal body, it can be divided into three categories: oblique, radial, and bevel.

Q:There is no clutch for the electric cylinder forklift

Electric didn't clutch, forward backward is controlled by a switch (similar to a steering switch) conductive to controller, again by the electrode control motor to realize the forward and backward