Fire-resistant Mica Tape for Cables See larger image Fire-resistant Mica Tape for Cables

Ref Price:

Loading Port:: China Main Port

Payment Terms:: TT OR LC

Min Order Qty:: -

Supply Capability:: -

Inquire Now

Add to My Favorites

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

Specifications

The tape is mainly used in the manufacturing of fire-resistant electric wire and cable.

Mica tape (for Fire-resistant wire & cable) consist of mica paper (phlogopite paper or synthetic mica paper), the non-alkali fiberglass cloth or Polyethylene film for reinforcement (single-side or double-side), and coupled by heat-resisting organic silicone adhesive, which is cut and processed into belted product after being baked and dried. It is featured in good insulation, fire resistance,good softness, ease of wrapping wires and cables. Hence, it is applicable to main fire-resistant insulation layers of various fire-resistant wires and cables.
Mica tape for fire-resistant wires and cables is mainly classified into the category A (950-1000°C) and B (750-800°C) base on the fire resistance grading. A may reach 1200°C,and the products in the category B are also able to normally work under the flame of 750°C for over 90 minutes.

Product Category:

Model	Name	Thickness	Application
NHJ-1	Single-side fiberglass enhanced phlogopite mica tape	0.12mm	B
NHJ-2	Double-side fiberglass enhanced phlogopite mica tape	0.14mm	B
NHJ-3	Fiberglass and film enhanced phlogopite mica tape	0.14mm	B
NHH-1	Single-side fiberglass enhanced synthetic mica tape	0.12mm	B, A
NHH-2	Double-side fiberglass enhanced synthetic mica tape	0.14mm	B, A
NHH-3	Fiberglass and film enhanced synthetic mica tape	0.14mm	B, A

Note: inner core is normally in 54mm, but can also be 76mm and 83mm; widths are available from 6mm, and when the width in 6-10mm, the outer diameter is about 240mm, can not be bigger; if the width bigger than 15mm, the maximum outer diameter can be about 340mm, but the production costs are higher too.

Technical specifications:

	Phlogopite Mica Tape	Synthetic Mica Tape
Classification	B (750-800°C)	A (950-1000°C)
Mica content (%)	Single-side reinforced type ≥60	Single-side reinforced type ≥60
Mica content (%)	Double-side reinforced type ≥55	Double-side reinforced type ≥55
Organic silica-gel content (%)	≤17	≤12
Volatile content (%)	≤1.0	≤1.0
Tensile strength (N/cm)	Single-side reinforced type≥20	Single-side reinforced type ≥20
Tensile strength (N/cm)	Double-side reinforced type≥100	Double-side reinforced type≥100
Dielectric strength (mv/mm)	≥10	≥10
Insulation resistance (MΩ)	≥1	≥0.4
Fire-resistant performance	No breakdown at 1KV, 800°C, 90min	No breakdown at 1KV, 1000°C, 90min

Q: Apple phone display cable or accessories not certified how to do: and then the audio cable and video cable [audio line (red and white), the first time the signal line (white) Video line (yellow)】 corresponding to the color connection set-top box with TV

Q: IPadmini. The latest version 7.1.1 up in the morning to see the non-stop display this cable is not certified does not support this feature. The The Charger original. Not on the computer charge. The Ask God to answer more: The problem lies in the charger between the machine, IPAD charging is to a charging protocol to complete, when the IPAD did not receive the agreement signal will be prompted: do not support this accessory, Apple's products have charging protocol, charging Is through the data line in the two lines and IPAD transmission charging protocol signal when ipad received the charging protocol signal after the machine internal charging circuit began to open the internal charging circuit to charge, the problem is to accept the charge signal is not so prompted not to Support, change the line to try

Q: Rt, the charger did not change, has been no problem before, today just plugged into the charger, the results appear as if the problem, before the out of this problem, and now only ipad power off after the power can not be charged, and ipad start , Then immediately prompted the title, can not charge more: The proportion of the cross-sectional area of the cable through the embedded pipe is 20%

Q: How to determine how much wire and cable should be used, the current load and how the corresponding wire, such as 4BV, under what circumstances, YJV240 what circumstances, the load is much more: According to the control cable and the power of the different layers of laying, if the power cable to be multi-layer need to have 300mm spacing (or load capacity is large enough), if it is control cable, casually laying, if the laying of power cable laying below Layer, above the laying of control cable, but not too much affect the power cable cooling. If the high-voltage cable and low-voltage cable in principle do not allow common laying.

Q: Apple mobile phone does not support this charge when charging this thing how to charge: I use the TV as a computer screen, connect the HD line, how no sound

Q: Decoration when the purchase of water pipes, wires and other items included in the account: Outdoor fire line must use fire-resistant KVV cable, wear pipe protection.

Q: Apple 6 Charging Why always show this cable has not yet been certified: Set-top box with the AV cable connection: yellow - video, red and white - audio, corresponding to the TV's AV input interface can be connected (do not receive the TV component interface). As for the emergence of partial pink, the possible reasons are: . poor contact. You will re-connect the three-color AV cable to the set-top box, on the TV, to ensure good contact. . cable quality. Three-color AV cable may not be the quality, if you can replace a group of try, or use the DVD and other equipment connected with the TV to test the AV line with or without problems. . TV AV input failure. You can use other video source equipment connected to the TV test, such as: DVD, VCD machines and so on. . set-top box failure. May be set-top box AV output port problems, if there are multiple sets of AV output, you can try other port okay, not the case may be the quality of set-top box, call customer service it.

Q: IPhone6 This cable or accessories have not been certified how to solve: Labor costs you can and workers to discuss, and some labor costs are calculated in accordance with square meters, and some are calculated in accordance with the day, the specific or ask the local construction team

Q: If you want to sell wire and cable, then what to do in advance to detect? The The The The The: Wire diameter, conductor resistance, insulation diameter, the thickness of the thinnest insulation,

Q: What is the warranty period for wire and cable?: Hello according to your request can be used two sets of ordinary 16 cascade, to a control terminal control 32 hosts. Is the cheapest solution. According to my understanding of the domestic Haikang series of products cost-effective, you can understand the next.

Send your message to us

*Email

*TEL

*Quantity

*Unit