Q:What is the 1.5-meter LEDT5 daylight lamp tube

It may also be used at the counter, which is about 1.5 meters in length. Actually, the only thing you can do is change the length when you drop the material. I make the special LED fluorescent lamp, the length is 1.9 meters. 2.5 meters and 2.8 meters, 1.5 meters in pediatrics. Ha ha

Q:LED T5 T8 and normal fluorescent lamps with no ballast

If the factory is to be refitted, it can change the LED fluorescent lamp of T5. If it is a new installation, choose LED operating lamp!

Q:Is a three-male LED fluorescent lamp? How the quality?

Mitsuo LED bulb, all is by the generation of processing products LED professional production enterprises, from mitsuo buy many, you can increase the cost of quality are ok, but I still suggest you still looking for a professional do the manufacturer of LED lamps and lanterns, will reduce a lot of cost for you!

Q:How does the LED fluorescent lamp tube be fixed with the aluminum plate in the tube?

The person thinks still silicon fat + screw, but the screw is not easy to install, do not know the big man has the gao zhao4?

Q:How does barton fluorescent lamp holder replace led lamp tube

LED lamp installation has a variety of methods, one of the most common is the old bracket of rectifier and remove the starter, then put in two wires direct access to the ends of the lamp holder.

Q:Can the LED tube be installed as a general lamp holder? It won't burn easily

Cannot be installed directly, need to change internal wiring. Leds are not the same as the traditional lamp tubes, which have the power supply inside the LED tube, and the input voltage at both ends of the tube is 220V. The traditional lamp power source is placed outside, and the voltage at both ends of the lamp is as high as a few hundred volts. If the LED tube is directly installed, it will burn down the power in the LED lamp tube because of the hundreds of volts of voltage that the original fluorescent lamp's ballast outputs. 3, therefore, the LED light tube cannot be installed directly in the traditional fluorescent tubes, the need to remove the internal ballast, then change the input at the ends of the line. LED bulbs are usually two incoming lines, one firewire and one zero line.

Q:What is the difference between the daylight lamp tube used in fishing steel and the normal lighting tube

Again, LED tube USES long life. LED can live up to 50,000 hours (without power), and the fluorescent tube (which does not contain power) can last 10,000 to 20,000 hours.

Q:It is the telephone of some enterprise management that asks me to take good use of, ask me how to use, how to contact them, what should I say when contacted I am a salesman

A lot of business today is telemarketing. 30 call a day is normal, this is to exercise their own, do not be afraid of failure, don't be afraid of rejection, specifically how to say, you can please teach you first job-seekers, observe how old colleague telephone communication

Q:Does the power drop when the lamp of fluorescent lamp declines

Because daylight through the electric current is determined by the current limit (ballast), so the lamp how basic will not affect the size of the total current, so what it consumed power will not change.

Q:What is the minimum starting voltage for the fluorescent tube?

The minimum maintenance of a fluorescent tube is 100V volts. 2 · the fluorescent lamp is in qi hui instant, the rectifier load voltage is 800 volts. (the function of the ballast). This 800 volt voltage is transient and can be observed with a digital oscillograph, and the 800v voltage is observed through the digital oscilloscope. I don't have any real data.