Q:What are the characteristics of a radiation dryer?

The gas heating dryer burns gas and heats the metal or ceramic radiant panel to 400~500 DEG C to produce infrared rays to heat the drying material

Q:What shall I do if the heating indicator of the air dryer is not extinguished?

Whether the inlet and outlet valve cannot be closed or closed completely, temperature rises less than conditions, causing the heater running

Q:What are the methods of use of the dehumidifier?

Ventilation and humidity reduction: it can send air into the room which is lower than the indoor air and the humidity is high, so that the humidity can be eliminated. The purpose of ventilation and humidity reduction can be achieved. Its disadvantage is that it can not adjust the indoor temperature

Q:What are the functions of a freeze dryer?

Compressed air contains 100% relative humidity water, and as it cools in the pipeline, water will precipitate, which brings many disadvantages to the gas equipment

Q:What are the cautions in the use of dryers?

When you open the dryer, you can not lift the lid, and use the left hand to hold down the dryer, the right hand carefully push the lid slightly, and so cold air slowly into, you can completely push, the lid must be tilted on the table

Q:What are the characteristics of a Dielectric dryer?

The dry material is placed in a high frequency electric field and heated by the alternating action of the high-frequency electric field

Q:What are the remarkable characteristics of CMD membrane dryer?

A more reliable and economical drying compressed air can be obtained

Q:What is the difference between the air dehumidifier and air dryer?

You should use an air dryer and add a steam separator and filter

Q:What's the difference between freeze dryer, micro heat regeneration dryer, non thermal regeneration dryer and waste heat regeneration dryer?

Waste heat regeneration dryer - as the name suggests, use other equipment or boiler heat to take over, will be heated again heating, in order to achieve better regeneration purpose, at the same time waste heat utilization to achieve energy saving purposes

Q:What are the factors affecting the dryer?

In the air around the particles, the absorption of heat and the diffusion of water molecules to the surface of the particles take a certain amount of time. Therefore, the resin supplier shall specify the time required for the effective drying of a material at the proper temperature and dew point.