Dehumidifier with 58 L/Day 50-60 Square Meter

Ref Price:
$206.00 - 309.00 / unit
Loading Port:
Shanghai
Payment Terms:
L/C,T/T
Min Order Qty:
100 Sets unit
Supply Capability:
2000 Sets per Month industrial air dehumidifier unit/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

58 L/DAY  50-60square meter Dehumidifier

X03221 

 

Details:

Dehumidification capacity: 58 L/DAY.

Volatge: 220V~50Hz.

Temperture range: 5°C~38°C.

Power: 900W.

Air Flow: 850m3/h.

Refrigerant: R22 .

Standard condition: T=27°C RH50%.

Applying area: 50-60 square meter  .

Machine size: 35*45*61CM.

Unite Weight: 25KG.

 

FAQ
Q 1.Okorder Quality Control?
We hold a very strict quality control system to check every connector of our products for

your safety.

Q 2: How do you care for your kitchen appliances?
A: Keep good Ventilation indoor. Open the doors of the kitchen appliances, if not. There

will be some mildew on cutting board and other kitchenware, because the water vapor can not

evaporate easily.
Keep clean of all the appliances. Each kitchen has its special cleaning fluid,please go to

Kitchen cleaning stores buy some clean them on time.

Q 3: Which one do you use the most of kitchen appliances?
A: Assuming you mean small appliances .I say too many! At one time we would buy every one

that came along; including a hot dog machine, pizza maker, elec. carving knife, elec.,

toaster oven,. Most have been garaged sale (sold) or are stored in the garage. Most used;

coffee maker, microwave, blender and mini food processor. OK?

 

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:What are the components of a microwave dryer?
The resonator, the heater, is a device that performs the interaction of microwave energy with the medium. The usual forms are case type, waveguide type, radiation type and surface waveguide type
Q:What's the difference between freeze dryer, micro heat regeneration dryer, non thermal regeneration dryer and waste heat regeneration dryer?
Waste heat regeneration dryer - as the name suggests, use other equipment or boiler heat to take over, will be heated again heating, in order to achieve better regeneration purpose, at the same time waste heat utilization to achieve energy saving purposes
Q:What is the principle of a spray dehumidifier?
When the temperature of the wet gas drops below the dew point, the steam condenses and reduces the humidity of the gas
Q:What are the characteristics of a convection dryer?
The humidity of the airflow has an effect on the drying rate and the final moisture content of the product
Q:What are the cautions in the use of dryers?
When you open the dryer, you can not lift the lid, and use the left hand to hold down the dryer, the right hand carefully push the lid slightly, and so cold air slowly into, you can completely push, the lid must be tilted on the table
Q:What is the working principle of the dryer?
The purpose of drying is for material use or further processing
Q:What are the clogging problems in dryer?
After the compressor starts running for a period of time, the condenser is not hot, no air cooling is blown out, hand touching the dry filter, chills, condensation or frosting, and the compressor sends out a muffled and overloaded sound
Q:What shall I do if the heating indicator of the air dryer is not extinguished?
Whether the inlet and outlet valve cannot be closed or closed completely, temperature rises less than conditions, causing the heater running
Q:What is the cause of the dryer blockage?
Dry filter "dirty block" is due to poor cooling system, so that the pipe wall peeling off
Q:What are the common breakdowns in the automotive dryer?
After the compressed air of the air compressor enters the dryer, the compressed air is leaked out through the throttle chamber, indicating that the piston or 0 ring seal in the dryer's throttling valve is damaged, out of slot and pulled out. Should be promptly checked, cleaned or replaced

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range