Air Water Generator 5000L/24 Hours
- Loading Port:
- Ningbo
- Payment Terms:
- L/C,T/T
- Min Order Qty:
- 1 Piece pc
- Supply Capability:
- 10 Pieces per Month pc/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Industrial/Commercial Atmospheric Water Generator with 5000L/24 Hours Water Making Capacity
Dimensions: 450 x 220 x 190cm
Gross weight: 1,800kg
Net weight: 1600kg
Water making capacity: 5,000L/24 hours (depends on temperature humidity)
Power consumption:
Rated making water input: 251kW
Maximum current: 115A
Refrigerant: R22 or R407 for your optional
Protection of compressor: three minutes delay
Power supply: 380V/50Hz
Wind volume: 56,000m³/hour
Obstruction of the wind:<180PA
Working temperatures: 15 to 32°C
Ideal temperatures: 24 to 29°C
Humidity: 40 to 95%
Ideal humidity: 70 to 80%
Filter system: PPF/T33/UDF/UF
Loading quantities:
One unit/20ft
Two units/40ft
They are high-technology and environmentally friendly products
Condense the moisture from air and turn it into pure water
Without any tap water
These large units (250l/d to 5,000l/d) can also equip with the external water tank for water collection although the machine have the internal water tank
And also can configure with the trailer and diesel generators to become mobile and provide power
Depend on the clients' needs
Please rest assured that we are the manufacturer, and have the patent right for above machines, don’t worry for any patent infringement cases
The consumption of electricity: 0.3 to 0.4kW/h per liter
All units are designed for contaminated air and water environments or just for healthy daily water supply
Our atmospheric water generators generate healthy water daily, filtering water three to four times in one circulation and killing bacterias with our UV technology
FAQ
Q 1.Okorder Quality Control?
We hold a very strict quality control system to check every connector of our products foryour safety.
Q 2: How do you care for your kitchen appliances?
A: Keep good Ventilation indoor. Open the doors of the kitchen appliances, if not. Therewill be some mildew on cutting board and other kitchenware, because the water vapor can not
evaporate easily.
Keep clean of all the appliances. Each kitchen has its special cleaning fluid,please go toKitchen cleaning stores buy some clean them on time.
Q 3: Which one do you use the most of kitchen appliances?
A: Assuming you mean small appliances .I say too many! At one time we would buy every onethat came along; including a hot dog machine, pizza maker, elec. carving knife, elec.,
toaster oven,. Most have been garaged sale (sold) or are stored in the garage. Most used;
coffee maker, microwave, blender and mini food processor. OK?
- Q:How to install the car air dryer?
- Installation: vertical, sewage (gas) mouth down, the slope shall not exceed the requirements of product specifications
- Q:What is the principle of a hydrogen dryer?
- The adsorption of water in the adsorbent during the regeneration process can be completely eliminated by the thermal diffusion mechanism of high quality regeneration gas (dry gas heating)
- Q:What are the methods of use of the dehumidifier?
- The main characteristics of liquid desiccant: air humidity reduction range, at lower temperatures can also achieve good results. However, the concentration of hygroscopic agent should be adjusted in time, and the corrosion inhibitor shall be added with corrosion inhibitor to prevent corrosion of the equipment
- Q:What are the factors that affect drying effect of dryer?
- In the dryer, the first is to remove the moist air so that it contains very little residual moisture. The air is then heated to decrease its relative humidity. At this point, the steam pressure of the dry air is low. After heating, the water molecules in the particles escape from the bond force and disperse into the air around the particles
- Q:What is the difference between the air dehumidifier and air dryer?
- You should use an air dryer and add a steam separator and filter
- Q:What's the difference between freeze dryer, micro heat regeneration dryer, non thermal regeneration dryer and waste heat regeneration dryer?
- The freeze dryer cools the compressed air to 2-10 degrees by freezing so that the air will dew and then separate and drain the water by mechanical separation, and the compressed air gets dry
- Q:What are the common types of fluidized bed dryers?
- According to the operating conditions, they can be divided into two types: continuous and intermittent
- Q:What are the common breakdowns in the automotive dryer?
- When the compression pressure reaches the required standard value, the exhaust valve D of the dryer can not stop under normal working conditions, indicating that the piston is caused by a foreign body, a strain or a dead card. The small piston and the sealing 0 ring shall be removed or checked or replaced promptly
- Q:What are the factors affecting the dryer?
- In the dryer, the wet air is removed first so that a very low residual moisture (dew point) is contained. The relative humidity is then lowered by heating the air. At this point, the steam pressure of the dry air is low. By heating, water molecules in the particles escape from the bond force and diffuse to the air around the particles.
- Q:What is the mean of Dehumidifier?
- The air can be contacted with the water nozzle, and the water temperature must be lower than the dew point entering the air, so that the water vapor in the air can be partially condensed and removed.
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
Air Water Generator 5000L/24 Hours
- Loading Port:
- Ningbo
- Payment Terms:
- L/C,T/T
- Min Order Qty:
- 1 Piece pc
- Supply Capability:
- 10 Pieces per Month pc/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Hot Searches
Related keywords