|Lamp luminous flux(lm):
||Led T8 induction lamp
||Aluminium profile +PC transparent cover
LED T8 induction lamp
LED T8 radar induction lamp is an intelligent energy-saving lamps, when people go into the radar induction area, The LED T8 tube lamp will be lit, when people go out of the induction area 1 minutes later, the T8 tube lamp will be turn off. When people enter the induction area (6-9 m) ,It is full brightness (9W). when people leave the induction area ,It is micro brightness (2-3W).the T8 tube lamp will be turn off of 1 minutes later.
It is using the underground garage, corridors, toilets, basement, garage, warehouse, office and other energy-saving automatic lighting occasions.
The lamp specifications is 36W(2pcs 18W tube) , its technical parameters as follows:
Light Source Type
Isolated Power Pass CCC,CE Certification
220--240V50 / 60Hz
95LM / W or more
20square meters - 25 square meters
|the underground garage, corridors, toilets, basement, garage, warehouse, office and other energy-saving automatic lighting occasions.|
Our business philosophy is"people-oriented, technology-first", "quality first, service-oriented" . environmental care into product designs - create a bright and beautiful, and dedication to provide customers with cheap and quality lighting products service, warmly welcome new and old friends at home and abroad patrons.
- Q:How do I get the four joints of the LED fluorescent tube
- I can't put a picture on it, you can try it yourself, add a rectification bridge at each end of the tube, and then you put the positive plus positive on both sides, negative plus negative, onto the next bridge
- Q:Use LED fluorescent lamp tube to replace, the line of original daylight-tube seat should be refitted
- If both ends with electronic ballast, it is necessary to put the two end of the circuit board uninstalled, two card old fluorescent lamp line sub respectively, and then to the outside power, install the LED fluorescent lamp with respect to OK.
- Q:How much is the ballast of the fluorescent tube coming out
- Because the ballast is in a series in the circuit, the output voltage is constant in normal circumstances, It's just that the electric light starts in an instant and produces a 600v-1500v pulse voltage that lasts about 1ms
- Q:How to meet? The rectifier is very easy to connect
- Went on two of the ballast with black and white and two sets of lines, a set of a tube, the last wire connects ballast is ok, if the change over time, to check whether a set of ballast to replace, so consider in ballast, if only a single change, that is about to change the bulb.
- Q:If the led lamp is replaced, the lamp power should be small
- Yes the LED lamps and lanterns is a new rising in recent years a new kind of technology With high wattage than the brightness of lamps and lanterns Good quality Is to use small LED chip do hair luminous brightness of the light source Wide Angle
- Q:Are LED lights like regular daylight bulbs
- LED is much better than ordinary lamp, won't produce ir/uv, not stroboscopic, is the lamp that shield an eye, for many people is too dazzling, can damage eyes, this is wrong, because the LED luminosity of relatively large, so will feel dazzling, it is like looking at the sun, but a lot of shell have frosted now, won't appear this kind of phenomenon; But ordinary lamp produces ultraviolet light and strobe, unfavorable to close for a long time of study and work, but also have a slight noise, leds will not have this kind of phenomenon. You need to know more about LED or purchased, and baidu HI.
- Q:How do fluorescent tubes clean
- Use alcohol as a wipe.I hope my answer will help you
- Q:What is the reason for the movement of light in the tube
- Lamp tube problem, get a hot towel tube to wipe, sometimes can solve.
- Q:Why do my electric cars charge when they open their homes
- It is possible that the high frequency pulse of the charger inside the charger is flowing into the power grid, causing the fluorescent lamp ballast to work and burn down. Electric car charger belongs to the circuit structure of the switching power supply, and the internal vibration circuit is used to produce high frequency signal to drive the transformer. Please use the TV interference method to test electrical good or bad. Put the charger in the TV next to blunt electricity. Television will have interference image will solve the problem that there is something wrong with the charger repair and replacement..
- Q:Is there any LED fluorescent lamp that can be used for more than five years?
- LED lights are used for start-up time, and if it is open tomorrow for four to five hours it should take five years, but there will be light decay.
1. Manufacturer Overview
|Annual Output Value
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
|No. of Production Lines
|Product Price Range