Laminate Flooring 12mm Export to Europe 2.2M Long Flooring
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 2000 m²
- Supply Capability:
- 2000000 m²/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Introduction:
Laminate flooring is a multi-layer synthetic flooring product, fused together with a laminationprocess. Laminate flooring ismost often four layers of materials,From topto bottom is Durable Overlay, Decorative Paper, HDF board, Balance Paper.
Durable Overlay is made by applying an AL2O3 solution over transparent paper, AL2O3 is very fineand thus it does not hide the color and design of the decorative paper.
Decorative Paperis a computer made paper which imitates natural wood, stone etc, by applying AL2O3to decorative paper, the latter becomes protected from the environment.
HDF board are made of wood fiber compressed into a high density panel (≥880kgs/m3).
Balance Paper is the thick and strong paper treated with AL2O3 on the back of laminate flooring,it gives stability to the laminate flooring boards and provide a measure ofisolation from under-floor humidity.
Wear Rating:
Durable Overlay Thickness | Applying Place | Euro Grade | EN438 | EN13329 | China National Stand |
22g/m2 | 21 Family Low Grade | AC1 | 2000 | ≥600 | 1500 |
33g/m2 | 22 Family Medium Grade | AC2 | 4000 | ≥900 | 2500 |
39g/m2 | 23 Family High Grade | AC3 | 6000 | ≥1800 | 4000 |
45g/m2 | 31 Commercial Low Grade | AC3 | 9000 | ≥2500 | 6000 |
62g/m2 | 32 Commercial Medium Grade | AC4 | 12000 | ≥4000 | 9000 |
76g/m2 | 33 Commercial High Grade | AC5 | 15000 | ≥6500 | 12000 |
Formaldehyde Emission:E1
Moisture Content:≤12%
Surface: Mirror, Middle Emboss, Fine Emboss, Crystal, Hand Scraped
Specification:
Thickness: 7.3mm,8.3mm, 12.3mm, 15.3mm
Based on order, other specification are alsoavailable.
Packing: 8-10 pieces per carton, 35-60 cartons perpallet, about 20 pallets per container.
- Q:How to strengthen the composite floor?
- Reinforced wood flooring accessories installation requirements: 1. The bottom mat can prevent the floor by wetlands, and between the ground and the floor from the buffer effect. When the mat is installed, the mats and mats can not overlap, and the interface is sealed with tape. 2. Geothermal ground, the first floor and large shopping malls and other ground to add 0.2 mm thick film, and every two films should be overlapped every 200 mm, and sealed with a tight strip. 3. Electric heating The ground is recommended to use anti-aging, good thermal conductivity of the material as a mat, in the full improvement of flexibility and reduce noise at the same time, electrical insulation protection must be improved. {TodayHot} 4. The quality of the skirting board must also meet the national standard requirements. Pavement process requirements: 1. Before installing the floor, doors and door sets must be set to the appropriate height to ensure the installation of the floor. 2. The floor of the pavement, requiring seams tight, no significant difference between high and low, no obvious gap. 3. The floor of the floor is determined by the special pad of adjustable width. 4. Construction, as far as possible to maximize the savings of materials. 5. When installing the skirting board, the height of the hole on the wall to be consistent, shall not damage the pipeline within the wall. 6. Requirements skirting board at both ends of the seam tight, highly consistent.
- Q:How to shop the natural wood flooring
- Multi-layer solid wood composite with the suspension of the shop on it
- Q:What about oak wood flooring?
- Genuine is still possible
- Q:Do you want to remove the original floor? Decoration company will take this little work? More
- Remove the original floor, buy solid wood flooring when talking about the installation of things, selling wood flooring generally contain the installation.
- Q:Room shop to strengthen the composite wood flooring with a good board or a good board?
- Personally feel that the small floor is good
- Q:How to clean the composite floor
- Composite floor cleaning method: 1. should immediately clean up the leak. Do not let any liquid stay on the floor for a long time, as they will contaminate the ground and damage protect the wear layer. Absorb excess liquid with a dry cloth or paper towel, do not keep the area moist. 2. After a period of time, the composite floor needs a thorough cleaning. As the water is the most modest cleaning possible. Do it every few months, except for regular sweep or when you notice that a zone is muddy or dirty. 3. If your hardened floor looks dirty and has mud stains, or if it begins to look fade, use a mixture of water and vinegar. Do not use vinegar in its pure form, because it is too corroded. The solution will bring the appearance of the floor luster and the smell of vinegar will disappear in a few minutes. If you hate the smell of a whale, you can add a few drops of lemon, mint or essential oil to the mixture. 4. found to cause chewing gum stains which are very difficult to get rid of, so that ice hardening it, gently scrape off. Be careful not to scratch the floor. Ice can also be used to remove chewing gum from the carpet.
- Q:Why is the middle of the composite floor plate foam
- First, the quality is not good, the second is damped. I hope my solution will help you
- Q:What do you need to pay attention to the installation of composite flooring?
- 1, clean the ground before installation. Especially where there is a "tumor" to eradicate. 2, will be wired, telephone lines, network cable layout. 3, if the wall of the heating tube too thick too deep, it is best to fill with dry sand. Do not use cement to seal! 4, if there is water pipes, heating pipe transformation must notify the installation of the master, so as to avoid accidents! 5, sprinkle the floor medicine, corner and door to sprinkle more. 6, asked the installation of the master will be under the door saw the saw, so that the floor inserted in the door under the set, so install more solid. 7, paved waterproof mats, if it is geothermal ground, must be used for geothermal mats. 8, before the installation of the best box to open, check the floor surface there is no corner (this situation is very small, but also to prevent). 9, be sure to keep the floor and wall 8mm telescopic space. 10, be sure to let each room into a plate. (At the door off, leaving the telescopic space) if it is a large area, each break 8-10 meters off once. 11, the installation of kicking angle, the best use of yin and yang angle, because the use of the yin and yang angle, kick the corner joints will be strong. 12, floor and kitchen floor tiles connection is best equipped with copper or stainless steel bar, do not use ordinary plastic strips. 13, before the completion of the installation must be fully accepted once again. 14, gold home building materials one-stop supermarkets all kinds of decoration materials are welcome to buy Oh!
- Q:What is the difference between the three-storey and multi-storey parquet? The more layers the better? More
- Three-layer solid wood flooring is the use of three different kinds of wood intoxicated Fengtong sedan tampering ax rough material from the surface layer of practical hard wood middle and bottom practical soft wood has added a solid wood elasticity has a relatively lower cost Multi-layer solid wood composite flooring with multi-layer plywood as the substrate surface mosaic hardwood sheet by aldehyde resin laminated
- Q:How about Sheng Chi composite floor
- I do not know how to build a hundred percent of the building materials where I have to sell ah I went to see the home decoration do not know what is good to see the effect of loading
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
Laminate Flooring 12mm Export to Europe 2.2M Long Flooring
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 2000 m²
- Supply Capability:
- 2000000 m²/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Hot Searches
Related keywords