white plastic can with line motor running capacitors

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Case:Round plastic case,quick connector terminals,anti moisture,anti explosion,good self-healing,good insulation etc.

AC film capacitors for general purpose applications (e.g. AC filters with harmonic frequencies exceeding 60 Hz), as well as for lighting and motor run applications.For the latter, AC capacitors are used in conjunction with asynchronous motors on single-phase mains supplies. They are designed for 50 or 60 Hz systems.


Applications:Asynchronous motors、Air conditioning、Domestic appliances、Compressors/pumps/garage、door openers、 Awning drives、 Heat pumps etc.



****Specifications****
Standard temperature
-40℃ ~ +85℃
Voltages Ratings
250V ~ 500V AC
Capacitance Range
1~60 uF
Applicable Standard
IEC60252-1:2011,GB/T3667.1-2005.UL810、EN60252-2:2011
Size


D±1mm
30
35
40
45
H±2mm
60-80
60-80
60-90
70-100


Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:How does the capacitor work? What does it do?
The bypass capacitor is an energy storage device that provides energy to the local device, which can equalize the output of the regulator and reduce the load demand. Like a small rechargeable battery, the bypass capacitor can be charged and discharged to the device. To minimize the impedance, the bypass capacitor should be as close as possible to the load device's power supply pin and ground pin.
Q:Low voltage capacitor voltage 0.45 and 0.4 What is the difference between usage
Can be used in the low-voltage three-phase power lines on the line, but the level of different pressure, connected to the 400V line, 450V capacitor capacity is 79% of rated capacity, 400V capacitor capacity is rated capacity. In the use of life on the 450V longer than 400V
Q:How to identify high voltage capacitors is good or bad
Test the resistance at both ends with a multimeter. If the use of a pointer multimeter, and most of the same capacitor, you can see the pointer from small to large a swing process. The difference is not the last return to infinity, but 10m. Inexperienced friends may think that the capacitor breakdown or leakage, in fact, not.
Q:How to use the capacitor
Solid-state aluminum capacitors have positive and negative points, do not reverse the solid-state aluminum capacitors, reverse solid capacitors can lead to a sharp increase in leakage current or reduced service life.
Q:What is the difference between the reactor and the capacitor?
Capacitors in order to boost, so that the voltage ahead; reactor in order to buck, so that the voltage lag; they are in the system are reactive power, improve power quality
Q:How to judge the capacitor is good or bad?
Measurement, the choice of multimeter R × 10k block, with two test leads were any then the capacitor of the two pins, the resistance should be infinite. If the measured resistance (pointer to the right swing) is zero, then the capacitor leakage damage or internal breakdown.
Q:Why some Y capacitor is very small, and some Y capacitor is very large?
As a capacitor of the Y capacitor, it is required to obtain the certification of the safety inspection mechanism. Y capacitor appearance is mostly orange or blue, are generally marked with safety certification mark (such as UL, CSA and other logo) and pressure AC250V or AC275V words. However, its true DC withstand voltage is above 5000V. It must be emphasized that the Y capacitor can not be used with a nominal capacitor such as the nominal voltage AC250V or DC400V.
Q:Why does the circuit current gradually decrease when charging the capacitor?
due to the increase in the number of charge, the electrostatic field field strength will gradually increase, increasing the field strength caused by the absorption of electrons to produce exclusion, So that the number of adsorbed charges gradually reduced, the number of charge to reduce the performance of the phenomenon that the charging current is gradually reduced. When the number of charges on the two electrode plates of the capacitor reaches a gradually increasing field strength constraint, the amount of charge is not increased and the equilibrium state is reached, that is, the charge saturation current is zero.
Q:What is the principle of capacitance isolation?
When the supply voltage rises in the reverse direction, the capacitor is charged in the reverse direction, and then the discharge is reversed. So the charge and discharge and the AC current is really the same, so the capacitor can pass the AC current.
Q:Use capacitance to do transformer how to calculate
Although the current flowing through the capacitor has 70mA, but in the capacitor does not produce power, because if the capacitor is an ideal capacitor, the current flowing through the capacitor for the virtual part of the current, the work done by the reactive power.

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range